Application value: When the data is set by pressing the "Up" or "Down" button, and then
press the "Apply" button at the bottom left corner, the value will be sent to the lamp
immediately, but the value is not saved.
Save the value: at any time, click the "OK" button at the bottom right corner to save the
current value to the internal memory, and the saved value will be applied to the lamp
when it is turned on next time.
3. Function Menu Description
1. Set DMX address code
The menu setting of lamps optimizes the address setting, and several operations for
setting address codes are as follows:
Select "Previous" or "Next", the lamp will automatically calculate the address code of the
next or previous set according to the current address code and channel data, which can
be quickly set;
Click the address code value to enter the value editing window, where you can set any
valid address code. The fixture automatically obtains the current channel number of the
lamp, and automatically filters the address code (512 - current channel number) that
cannot be used.
The fixture supports RDM protocol, and the lamp address code can be set remotely
through RDM.
Two buttons are provided:
To Next Page
Loading...