Lamp/Reset(CH16): 100-105 (LAMP OFF)
200-205 (LAMP ON)
240-255 (RESET ALL)
Chapter 4 Common Faults and Precautions
1. Common fault handling
The fixture contains microcomputer circuit board, high-voltage power supply and
other professional components. For your safety and product life, no professionals
are not allowed to dismantle the fixture and related accessories without
authorization.
1. The bulb does not light up (except for LED light source)
Possible causes: The bulb is not completely cooled, or the bulb has reached its
service life. The treatment is as follows:
Due to abnormal operation, the bulb is not completely cooled, so the lamp body
should be allowed to cool for more than 10 minutes to fully restore its interior to
normal state, and then start the power supply again;
Check whether the bulb has reached its service life, and replace it with a new one;
Check whether the circuit between the bulb and the lamp lighter leaks, falls off or
has poor contact;
Replace with a new lamp lighter.
2. The beam appears dim
To Next Page
Loading...