Place the chair on a at surface and make sure it is sitting
solid on both legs and both sides. If it is not sitting at,
remove the single screw holding the bottom of the strut
down and move the strut up or down to compensate. When
the adjustments are done, attach the struts with two screws
each (and glue Tec7).
step 11.
Attach the additional arm support (#6) to the inside of the
struts, underneath the back of the arms through the pre-dril-
led holes with four screws.
Pre-drill with a wood drill bit (3 mm) is recommended.
step 12.
6.
Knock the caps under the legs and t the brass plate on the
front of the chair.
step 13.
Remove any adhesive from the chair and sanding rough parts
smooth. Your seat is ready for use.
step 14.
Zet op vlakke ondergrond
Enjoy your Bear chair
To Next Page
Loading...