Bear chair BC201 User Manual

INSTRUCTIONS KIT BEAR CHAIR BC201
1.
2.
3.
4.
5.
5.
6.
8.
8.
4.
3.
4.
9.
11.
12.
13.
7.
14.
10.
1.
Parts list:
NR. parts Quanty
1. Legs 2
2. Seat slats 6
3. Arm support 2
4. Triangles 2
5. Arms 2
6. Additional Arm Support 2
7. Struts 2
8. Sides , left (L) en right (R) 2
9. Bottom Back Support 1
10. Back Slats 7
11. Top Back Support 1
12. Frontm Slat 1
13. Comfort Slat 1
14. Plated Screws 68
14. Brass Plaque 1
Note:
Put any loose parts ordered on the ground and check the numbers! Shed there, where necessary,
rough parts are smooth. Check before you glued, or glueing the right parts.
Read the installation requirements before you begin. Good luck with the installation!
Bear chair Nederland
Postbus 500
3700 AM Zeist
Original Bear Chair BC201

Bear chair BC201 Specifications

General

Brand	Bear chair
Model	BC201
Category	Indoor Furnishing
Language	English

Summary

Parts Identification and Overview

Parts List

Detailed list of all components included in the kit with their quantities.

Assembly Steps

Step 1: Assemble Back Supports and Slats

Attach bottom and top back supports, arrange seven back slats on supports.

Step 2: Space and Secure Center Back Slat

Space slats evenly, screw only the center slat using pre-drilled holes.

Step 3: Attach Remaining Back Slats

Space remaining slats evenly, align with back support curve, and attach.

Step 4: Attach Legs to Sides

Attach legs to sides using four screws, aligning with pre-drilled pilot holes.

Step 5: Attach Front Slat to Sides

Place sides facing each other, attach front slat to the front of the sides.

Step 6: Integrate Back Assembly with Sides

Place back assembly into cut-out area on sides and attach with screws.

Further Assembly and Refinements

Step 7: Place Comfort and Seat Slats

Place comfort slat and six seat slats on sides, space evenly.

Step 8: Attach Arm Supports and Triangles

Attach arm supports to legs, insert triangles, and secure with screws.

Step 9: Attach Struts to Back Assembly

Attach struts to the underside of top back support and sides.

Step 10: Attach Arms to Struts

Attach arms to struts and arm supports using screws.

Final Assembly and Finishing Touches

Step 11: Adjust and Secure Struts

Place chair on flat surface, adjust struts for stability, and secure.

Step 12: Attach Additional Arm Supports

Attach additional arm supports to the inside of the struts.

Step 13: Fit Caps and Brass Plate

Knock caps under legs and fit the brass plate on the chair front.

Step 14: Clean and Prepare for Use

Remove excess adhesive and sand rough parts for a smooth finish.

Important Considerations

Self-Assembly Conditions

Check parts, report missing/damaged items promptly, and use specified tools.

Material and Adhesive Notes

Use only specified screws, Canadian Bitje, and Tec7 adhesive for best results.