Your BearDevil’s Anatomy
08 09
Setting Up
Your BearDevil
1 If you’re using your BearDevil for the first time, you should charge
the battery for at least ten hours.
2 Make sure your BearDevil is turned off before inserting or
removing a memory card.
3 Screw off the rear cap at the back of your BearDevil.
4 Insert an empty, formatted MicroSD memory card (up to 32GB, Class 6
or higher) into the rear slot with the label facing down. The MicroSD
card will click into place when inserted correctly.
5 Replace the rear cap.
6 Boom! You’re ready to start recording your awesome life!
1 LED
2 Power / Shutter
3 Rear Cap
4 Mode Switch
5 USB
6 MicroSD Card Slot
7 Battery
8 Microphone
3
1
2
5
6
7
4
8
EN
To Next Page
Loading...