BearDevil Red User Manual

12 13
To take pictures with your BearDevil, make sure a MicroSD
card (class 6 or higher) is inserted, flick the Video/Photo
Switch to Photo Mode and turn the BearDevil on. Shortly press the Power/
Shutter Button to start and stop taking photos. The BearDevil will take a
photo every 3 seconds, the red LED flashing to indicate it is doing so.
Recording HD Video
To record HD video with your BearDevil, make sure a
MicroSD card (class 6 or higher) is inserted, flick the
Video/Photo Switch to Video Mode and turn the BearDevil on. Shortly press
the Power/Shutter Button to start and stop recording. The red LED will flash
while the BearDevil is recording.
Taking Pictures
The battery in your BearDevil is designed to fit tightly in
order to maximize reliability during rough activities. To
remove the battery, pull it out with the battery holder. It
is intentionally not easy to do, but the battery will come out. Have faith!
Additional batteries and accessories are available at
www.BearDevil.com
Removing the Battery
Going Under Water?
To keep your BearDevil waterproof, make sure the O-rings
are always sufficiently greased with the silicon grease,
and the rear cap is screwed on tight.
Rubber O-ring
with silicon grease
This cow represents
the Rear Cap
This guy
represents your
BearDevil Red
*
EN

BearDevil Red Specifications

General

Brand	BearDevil
Model	Red
Category	Action Cameras
Language	English