17
9 Trademark And Legal Declaration
“ ”、“
BeaverLAB
" is a trademark applied for or registered in Chinese Mainland by Beaver
Technology Co., Ltd. and is used on this product use. Without the permission of thetrademark owner, no
person or institution may use the above trademark logo on unapproved goods without authorization.
This manual is made and copyrighted by Beaver culture and innovation technology (Shenzhen) Co.,
Ltd. no organization or individual may copy or distribute all or any part of this manual without permission.
Due to the continuous improvement of product functions, design changes and other reasons, this manual may be
inconsistent with the products you purchased. Please take the actual products as the standard. Product executive
standard: GB 4943.1-2011 GB / T 9254-2008
The device cannot be used
normally
Internal damage of equipment due to
water spray, collision and other reasons
Send for repair *Man made damage is not
covered by warranty
The device cannot be
connected to the
computer software
The interface is not plugged tightly,
the data line is damaged, and the
connecting line with data transmission
function is not used
Reseat the interface, replace the data
cable, replace the data cable with data
transmission function, and
then connect it for use
Lens display image blur
The ambient temperature changes
sharply, causing the
lens to fog
Wait for the temperature to be
constant and use it after the fog
disappears for a period of time
There are foreign bodies in the
specimen and the observation is
not clear
The surface of the specimen is dirty,
and the panel is dirty
Wipe the surface of the specimen
and the surface of the observation panel
The shell is broken and cracked
due to falling and impact
Damage caused by external use
Man made damage is not covered
by the warranty
The product cannot be turned off
or the key fails
Crash Please reset and restart
To Next Page
Loading...
