BEC 7800TN - Page 8

8
Setup – Static IP
This section is only for customers with a static IP.
If customer is DCHP then proceed to “Setup – Main Port” on page 12
To configure the modem with the customers static IP click on the "WAN Service" link to the left. Here
you’ll see two different interfaces.
If the modem is on an ADSL connection then click the “Edit” button for the interface “atm0” and
proceed to the next page.
If the modem is on a FTTP connection then click the “Edit” button for the interface “eth4” and proceed
to the next page.
Back to Top