Y8627 Rev. E
PRIMARY
AUTOMATIC CONDENSATE UNIT
Keep For Future Reference
INSTALLATION OPERATION
CAUTION:
CAUTION:CAUTION:
CAUTION:
Read rules for Safe Operation and Installation.
Models:
CB221UL - 115V
CB222UL - 230V
CB222CE - 230V
CB222TCE - 230V
1. Carefully read the Owners Manual and rules for safe operation.
2. All wiring must conform to local codes. Use the National Electric Code if local code is nonexistent.
3. CAUTION! To reduce risk of electric shock disconnect form power supply before servicing, pull the plug on models which have
plug-in connections.
4. Do not handle the pump with wet hands or when standing in water as fatal shock could occur. Disconnect main power before
handling unit for ANY REASON!
5. Protect the power cable from coming in contact with sharp objects.
6. Do not kink power cable and never allow the cable to come in contact with oil, grease, hot surfaces or chemicals.
7. Make certain that line voltage conforms to the voltage specified on motor and nameplate.
8. WARNING! To reduce risk of electrical shock, connect only to a properly grounded grounding type receptacle.
INSTALLATION
Select a location for the pump. It should be as
near as possible to the air conditioning coil.
The pump must be level. The inlet hole must
be below the coil drain.
Carefully unpack the pump. Remove the
switch/motor cover. Check each float arm for
“free” action.
Owners Manual
Model: CB22
20’ LIFT
PRIMARY
STAND
INTRODUCTION
INLET
SAFETY
FLOAT
OUTLET
MOTOR
Irving, Texas
www.beckettpumps.com
Toll Free: 1-888-232-5388
© 2011 BECKETT CORPORATION All Rights Reserved
Derechos Reservados / Tous droits réservés
NOTE
：
：：
：
The electrical cord of the UL models is provided with a plug.
The electrical cord of the CE models does not have a plug.
To Next Page
Need help?
General
