Mechanical installation
Version: 2.1 ─── 41AS2000
Mounting
Do not touch hot output elements without personal protective
equipment
Only handle hot output elements, such as couplings or pulleys,
with special thermal gloves. Avoid prolonged contact with hot com-
ponents.
Hot components can cause severe burns to body parts and limbs.
Do not mount the drive element offset
Place the drive elements centered and straight on the motor shaft.
An offset will cause unacceptable vibration and the destruction of
the ball bearings and the coupling.
► Warm up the output element according to the vendor's instruc-
tions
► Remove the protective cap
► Degrease and clean the motor shaft
► Remove the output element from the oven and transport it to the
workstation
► Place output element 1 centered and straight on the motor shaft
2
► Insert washer 3 with screw 4 of strength class 8.8 and nut 5 into
the locking thread 6 of the motor shaft
► Tighten nut 5
The output element is pulled onto the motor shaft by the nut.
To Next Page
Loading...