Decommissioning
Version: 2.1 ─── 57AS2000
Decommissioning
Disassembly may only be carried out by qualified and trained per-
sonnel. For more information please refer to Chapter: "Documenta-
tion notes", [Page5].
When disposing of electronic waste, make sure that you dispose of
it in accordance with the regulations applicable in your country.
Read and follow the instructions for proper disposal.
Disassembly
Risk of injury from leaking oil
Prevent oil from leaking. Let it cool down before starting work.
Soak up any leaked oil with approved binding agents. Mark the
danger spot.
Leaking oil can cause slips and falls, resulting in serious or fatal
injury. Hot oil can cause severe burns.
Impermissible removal of motor components
The motors have permanent magnets in the rotor. These motors
may only be dismantled by Beckhoff Automation GmbH & Co. KG.
Contact Beckhoff Service for further information.
Removal of the motor from the machine
• Remove cables and electrical connections
• Cool and drain liquids, then remove
• Remove supply lines and water hoses
• Loosen and remove the fixing screws of the motor
• Transport the motor to the work area or store it
Disposal
When you dispose of your motor, observe the following instructions
for the proper disposal of the components:
Cast iron and metal
Cast and metal parts can be handed over to scrap metal recycling.
Plastics and hard plastics
Plastic and hard plastic parts can be recycled via the waste man-
agement center or reused in accordance with the component regula-
tions and labels.
Oils and lubricants
All oils and lubricants used in the motor and the machine / system
must be collected in separate containers and disposed of at a waste
oil collection point.
Disposal by the manufac-
turer
In accordance with the WEEE 2012/19/EU Directives we take old
devices and accessories back for professional disposal, provided
the transport costs are taken over by the sender.
Send the devices with the note “For disposal” to:
Beckhoff Automation GmbH & Co. KG
Huelshorstweg 20
D-33415 Verl
Alternatively, you can contact a certified specialist disposal company
for waste electrical and electronic equipment in your area. Dispose
of the old components in accordance with the regulations applicable
in your country.
To Next Page
Loading...
Need help?
General
