4
Pull the DC power cords toward the direction of the AC power sources through
either the bottom or the side of the bed frame. Pull the two motion sensors to the
two sides of the bed frame. Make the bed completely flat
with a flipping motion
.
DONE!
6
Uncoil the AC power cords, connect the DC power cords to the power supplies and
then connect the power supplies to the AC power sources.
HEADBOARD
AC
Power Source
AC
Power Source
DC Power Cord
DC Power Cord
AC Power Cord
AC Power Source
DC Power Cord
Power Supply
AC Power Cord
AC Power Source
Power Supply
DC Power Cord
HEADBOARD
Insert the batteries into
the 2 remote controls.
×2×2
AAA
AAA
AAA
5
2
1
Insert the flat mattress retainer bar into the
securing strap at the bottom of the BEDGEAR
mattress and then snap it into the mattress
retainer mounts.
Installation method 1:
(Exclusively for BEDGEAR Mattresses)
one side after another for non-BEDGEAR
mattresses.
Alternatively, install the mattress retainer bar
Installation method 2:
- 8 -
To Next Page
Loading...