IMPORTANT INSTRUCTIONS
USER OPERATING MANUAL – MODEL 1222NA/2222EU
Revision 1.0 P a g e | 3
10. Always unplug device when not in regular use. Unplug power cord before servicing or
moving the device. WARNING: DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE
MEANS OF DISCONNECTING POWER WHEN SERVICING OR MOVING THE DEVICE. ALWAYS
UNPLUG THE POWER CORD.
11. Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening
as it may cause an electric shock, fire, or damage the device. Do not block or tamper with
the device in any manner while it is in operation.
12. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not place
unit on soft surfaces, like a bed, where openings may become blocked.
13. Always place the device on a stable, flat, level surface when operating, to avoid the chance
of the device overturning. Locate the power cord so the device or other objects are not
resting on it. Do not run cord under carpeting. Do not route cord under furniture or
appliances. Arrange cord away from traffic area and where it will not be tripped over.
14. This device has hot and arcing or sparking parts inside. Do not use the BedJet in areas where
gasoline, paint, or flammable liquids or flammable gases are used or stored. It must NOT be
used in potentially dangerous locations such as flammable, explosive, chemical -laden or wet
atmospheres.
15. This device is not intended for use in wet or damp locations. This device is NOT INTENDED
for use in bathrooms, laundry areas and similar indoor locations. Never locate the device
where it may fall into a bathtub or other water container. Do not immerse BedJet in water
16. This device is not intended for use as a room air heater.
17. Do not use device outdoors.
18. Keep the cord away from heated surfaces.
19. Do not operate where aerosol (spray) products are being used or in oxygen rich
environments.
20. Check your BedJet cord and plug connections:
a) Faulty wall outlet connections or loose plugs can cause the outlet or plug to overheat.
Be sure the plug fits tight in the outlet.
b) Heaters draw more current than small appliances, overheating of the outlet may occur
even if it has not occurred with the use of other appliances.
c) During use check frequently to determine if your plug outlet or faceplate is HOT!
d) If so, discontinue use of the heater and have a qualified electrician check and/or replace
the faulty outlets.
To Next Page
Loading...