BedJet 6002NA V2 - BedJet Installation Steps Part 1

USER MANUAL – MODELS 6002NA/V1/V2/ & 7002xx
QUESTIONS? EMAIL US AT INFO@BEDJET.COM OR CALL 401-404-5250
WE ARE HERE TO HELP – PLEASE CALL US FOR ADVICE!
Revision 1.6 www.bedjet.com P a g e | 14
3) Determine best Air Nozzle location near the bottom of the bed per your personal heating
and cooling zone preferences on the chart below and limitations of your bedframe. It’s
good to experiment with these over a few nights to learn what works best for you. For
installations using AirComforter, please consult instructions found in the AirComforter
package, available Nozzle locations will be different than shown below.
4) Locate parts for adjustable Hose Mattress Mount assembly. The adjustable Hose Mattress
Mount comes in multiple pieces:
Whole bed warming and
cooling, slightly favors
left side on low air
settings (best)
Mostly left side of bed
warming and cooling
Mostly right side of bed
warming and cooling
Whole bed warming and
cooling, slightly favors
right side on low air
settings (best)
Middle of bed warming
and cooling
Hose Grip with
2 sheet Clamps
Height Extending Links, slide in
to snap lock, press tab to
release and pull apart
Mattress Mount Base