EasyManua.ls Logo

Beechcraft Baron B55 User Manual

Beechcraft Baron B55
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Military Visualizations Beechcraft® Baron® B55 Quick Start Guide
Here it is! The bare bones! The “kick the tires and light the fires and get airborne guide.”
You read this and you get off the ground. You want to
learn how the airplane actually works and flies properly,
then you read the Pilot’s Operating Handbook (POH)
when you feel like it.
Step one: You have booted up FSX in Free Flight and
you’re sitting in the cockpit. On the keyboard, press Shift-
1 to bring up the setup menu box (figure 1). If you
want a two-blade prop, click the “Swap Props” button Figure 1
red. You want three blades again, click it green! You want to remove the chocks, click that
button. Click it again to bring them back. You want the pilot visible and the engine plugs and
pitot covers removed, then click that button to make it green. Want the pilot gone and the
plugs and covers back, click it red.
Step two: You want to light the fire! OK, here’s how:
1. On the left side of the cockpit, beside the yoke, see that box (figure 2)? It has your starter
buttons, master battery switch, and left/right
alternator switches. See the triangular arrayed
switches (figure 3)? The top of the triangle is the
master battery. The two base switches are the left
and right alternator switches. Flip all three up to the
on positions.
Figure 2
2. Look in the center of the panel, see those six levers? The two in the middle are your
throttles that’s right Beech put the throttles for the Baron 55 in the middle! Use your
keyboard, mouse, or your physical controllers and push those two throttles forward about a
half inch forward from the full aft position. Make sure your two prop control levers are full
forward and the two mixture levers are full forward.
3. See that huge yoke? Covers up near everything doesn’t it? Let’s hide it temporarily!
See the bare aluminum shaft that pierces the panel in the center? Hover your mouse pointer
Figure 3
Question and Answer IconNeed help?

Do you have a question about the Beechcraft Baron B55 and is the answer not in the manual?

Beechcraft Baron B55 Specifications

General IconGeneral
ManufacturerBeechcraft
ModelBaron B55
Engine TypePiston
Number of Engines2
EnginesContinental IO-470-L
Horsepower260 hp each
Seating Capacity6
Range1, 000 nautical miles
Wingspan37 feet 10 inches (11.53 m)
Height9 feet 7 inches
Max Takeoff Weight5, 100 lb (2, 313 kg)

Summary

Military Visualizations Beechcraft Baron B55 Quick Start Guide

Initial Setup and Configuration

Configure aircraft settings like propeller blades, chocks, and pilot visibility via the setup menu.

Engine Start Procedures

Activate battery, alternators, and starter buttons to begin engine ignition.

Cockpit Systems and Pre-Flight Checks

Avionics and Lighting Activation

Turn on avionics and lights using the radio stack and pilot panel switches.

Taxiing and Airspeed Management

Prepare for taxi, line up for takeoff, and verify airspeed and engine instruments.

Takeoff and Climb Procedures

Takeoff Roll and Gear Retraction

Achieve rotation speed, lift off, and retract landing gear once airborne.

Climbing and Cruise Settings

Set engine parameters for climb, including manifold pressure and RPM, and trim the aircraft.

Landing Procedures and Techniques

Approach and Flap Configuration

Configure flaps and manage airspeed for a stable approach to landing.

Final Approach and Touchdown

Execute the landing phase, including flare, touchdown, and crosswind correction.

Related product manuals