Beem MD-258BT - Coffee Flow Issues; Steam and Smell Issues; Warranty and Liability

EN 28
Problem Possible cause Fix
The coffee runs very
slowly into the thermal
jug (6).
The drip stop is blocked.
Clean the fi lter holder (9) with
drip stop.
The device is furred up. Descale the device.
The coffee powder used is too
fi nely ground.
Use coffee powder with a
coarser grind.
Too much coffee powder used.
Do not overfi ll the permanent
fi lter (8) / fi lter paper.
The coffee is too thin.
There is too much water in the
water tank (8).
Pour only the quantity of water
required for the number of cups
you want into the water tank.
A large amount of
steam is produced in
the brewing process.
The device is furred up. Descale the device.
During use, an
unpleasant smell is
detected.
The device is being used for the
fi rst time.
A smell often develops when new
devices are fi rst used. The smell
should disappear once the device
has been used several times.
The device has previously been
descaled.
Rinse the device with clear water.
Warranty and Limitations of Liability
The warranty does not cover faults caused by incorrect handling, calcifi cation, damage or
attempted repairs. The same applies to normal wear and tear.
We do not accept any liability for damage or consequential damage resulting from:
• failure to follow the operating instructions
• non-designated use
• improper or unsuitable handling
• repairs which are not carried out properly
• unauthorised modifi cations
• use of outside parts or spare parts
• use of unsuitable additional parts or accessories
Keep the original packaging during the warranty period of the device so that the device
can be properly packaged up if it needs to be returned. The warranty claim will lapse if any
damage is caused during transport.
02442_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 2802442_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 28 06.12.2019 11:35:0206.12.2019 11:35:02