Beem Multi-FiXX 500 - Troubleshooting

28
Multi-FiXX 500 EN
BEEM - Elements of Lifestyle
Troubleshooting
The following table helps in localising and remedying minor faults:
Fault Possible cause Remedy
The appliance does not
work after turning the
rotary switch.
Plug not inserted into socket. Insert plug.
Automatic circuit breaker in
electrical distribution board
tripped.
Switch on the automatic
circuit breaker again.
The internal safety switch has
switched off the appliance as
a result of overheating.
Allow the appliance to
cool down.
The jug and/or the kid is not
tted properly.
Fit and lock the jug and
lid properly.
The automatic circuit
breaker in the electrical
distribution board trips.
Too many appliances connect-
ed to the same power circuit.
Reduce the number of
appliances on the power
circuit.
Appliance is defective.
Contact customer
service.
Motor runs extremely
slowly or stops.
Jug overlled.
Remove some of the
ingredients.
Pressure too strong. Exert less pressure.
NOTE
If you cannot resolve the problem with the steps described above, please contact ►