Requirements for the place of use
For safe and trouble-free operation of the
appliance, the place of operation must sat-
isfy the following requirements:
Place the appliance on a dry, at, wa- ■
terproof and heat-resistant surface.
The surface nishes on furniture may ■
contain substances that can be detri-
mental to the rubber feet of the appli-
ance. If necessary, place a mat under
the feet of the appliance.
Do not install the appliance in a hot, ■
wet or very humid environment.
Select a location that does not allow ■
children to reach the hot surfaces of
the appliance.
The mains socket must be easily ac- ■
cessible and allow fast disconnection
in the event of an emergency.
Electrical connection
For safe and trouble-free operation of the
appliance, the following instructions must
be observed for the electrical connection:
Before connecting the appliance, ■
compare the connection data (voltage
and frequency) on the rating plate with
those of your mains power supply. The
data must correspond in order to avoid
damage to the appliance. If in doubt,
ask your electrical appliance retailer.
The mains socket must be protected ■
by at least a 10 A automatic circuit
breaker.
Ensure that the mains cable is undam- ■
aged and is not laid over hot surfaces
or sharp edges.
The connecting cable must not be ■
strained or bent.
The electrical safety of the appliance ■
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualied
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.
Appliance description
(refer to the fold-out page for illustration)
Temperature regulator1
Temperature indicator light (green), 2
top
Power indicator light (red)3
Lid4
Supports5
Handle6
Temperature indicator light (green), 7
underside
Hotplates8
Base9
Clip for vertical position10
Locking lever11
User manual (not illustrated)12
Temperature controller
Proceed as follows to set the temperature:
Turn the temperature regulator (1) to
the desired level:
Symbol Meaning
0 Heating off
Min lowest temperature
Max highest temperature
To Next Page
Loading...