Beem Waffel-Flipp - Troubleshooting Common Faults

26
Waffel-Flipp EN
BEEM - Elements of Lifestyle
Troubleshooting
The following table helps in localising and remedying minor faults:
Fault Possible cause Remedy
The power indicator does
not light up after inserting
the mains plug.
Automatic circuit breaker in
electrical distribution board
tripped.
Switch on the automatic
circuit breaker again.
Power indicator defective.
Contact customer
service.
The temperature indicator
lamp does not light up dur-
ing heating.
Temperature indicator light
defective.
Contact customer
service.
The automatic circuit
breaker in the electrical
distribution board trips.
Too many appliances connect-
ed to the same power circuit.
Reduce the number of
appliances on the power
circuit.
No fault detected.
Contact customer
service.
Wafe mixture oozes out
of the sides.
Too much wafe mixture lled.
Fill with less wafe
mixture.
NOTE!
If you cannot resolve the problem with the steps described above, please contact ►
customer service.