Behringer BASS OVERDRIVE BOD400 User Manual

BASS OVERDRIVE BOD400
Thank you for showing your confidence in us by purchasing the BEHRINGER BASS
OVERDRIVE BOD400. This high-quality effects pedal is specifically designed for bass
applications. Thanks to its high-performance features you will achieve tube-like distortion,
smooth sustain and super fat tone with maximum punch.
1. CONTROLS
Top view
The LEVEL control adjusts the output level.
The HIGH control allows you to boost/cut the high-frequency range.
The LOW control allows you to boost/cut the low-frequency range.
Use the GAIN control to adjust the amount of overdrive.
With the BAL(ance) control you can adjust the amount of the dry direct signal and
the effect signal.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be
careful not to scratch the unit.
 The BOD400 has no on/off switch. As soon as you insert the jack into the
IN connector, the BOD400 begins running. When not using the BOD400,
remove the jack from the IN connector. This extends the life of the
battery.
The SERIAL NUMBER is located at the bottom.

Behringer BASS OVERDRIVE BOD400 Specifications

Power

power supply voltage	9 V
power supply current	100 mA
battery type	9 V type 6LR61
power consumption	30 mA

Impedance and Connectors

input connector	1/4" TS
input impedance	500 kΩ
output connector	1/4" TS
output impedance	1 kΩ

Weight and Dimensions

height	54 mm (2 1/8")
width	70 mm (2 3/4")
depth	123 mm (4 4/5")
weight	0.33 kg (0.73 lbs.)

Summary

Controls Overview

LEVEL Control

Adjusts the output level.

HIGH Control

Allows to boost/cut the high-frequency range.

LOW Control

Allows to boost/cut the low-frequency range.

GAIN Control

Adjusts the amount of overdrive.

BAL(ance) Control

Adjusts the amount of dry direct signal and the effect signal.

ON/BATT LED Indicator

Indicates effect activation and battery level.

Footswitch Operation

Activates/deactivates the effect.

Instrument Input

1/4" TS IN connector to plug in the instrument cable.

Amplifier Output

1/4" TS OUT connector sends the signal to your amp.

Specifications

Input/Output Connectors

Details on 1/4" TS connectors and impedance.

Power Supply Requirements

Specifies voltage, current, and connector type for power.

Physical Dimensions and Weight

Provides size (H x W x D) and weight of the pedal.

Safety Instructions