Behringer ULTRA BASS FLANGER BUF300 - User Manual

ULTRA BASS FLANGER BUF300
Ultimate Bass Flanger Eects Pedal
Thank you for showing your condence in us by purchasing the BEHRINGER ULTRA BASS FLANGER BUF300.
This high-quality eects pedal delivers incredible anging eects specially designed for bass guitars to
take your sound to a new level.
Originally, the anger eect was generated by using two tape recorders running synchronously.
The same audio signal was recorded on both machines. If you put a nger on the left spool of one
of the machines, the spool and the playback speed are slowed down. The generated delay results in
phase shifting of the signals.
1. Controls
(1) The MANUAL control adjusts the starting point for the modulation of the anging eect.
(2) The DEPTH control adjusts the anging range that is altered by the center frequency set
with the MANUAL control.
(3) The RATE control determines the speed of the anging eect.
(4) The RES(onance) control determines the amount of output signal fed back to the anger input to
increase the resonance frequency. That way the anging eect gets more intensive.
(5) The ON/BATT LED illuminates when the eect is activated. It also serves as a battery level indicator.
(6) Use the footswitch to activate/deactivate the eect.
(7) Use this ¼" TS IN connector to plug in the instrument cable.
(8) The ¼" TS OUT connector sends the signal to your amp.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery,
press the hinges with a ballpen and remove the pedal cover. Be careful not to scratch the unit.
(1)
(8)
(5)
(4)
(7)
(6)
(3)
(2)

Behringer ULTRA BASS FLANGER BUF300 Specifications

Input/Output

in connector type	1/4" TS
in impedance	500 kΩ
out connector type	1/4" TS
out impedance	1 kΩ

Power

power supply voltage	9 V
power supply current	100 mA
battery type	9 V type 6LR61
power consumption	30 mA

Physical Characteristics

dimensions (H x W x D)	54 x 70 x 123 mm
dimensions (H x W x D) (inches)	2 1/8 x 2 3/4 x 4 4/5"
weight	0.73 lbs
weight (kg)	0.33 kg

Summary

Controls Overview

MANUAL Control

Adjusts the starting point for the modulation of the flanging effect.

DEPTH Control

Adjusts the flanging range altered by the center frequency.

RATE Control

Determines the speed of the flanging effect.

RES(onance) Control

Increases resonance for a more intensive flanging effect by feeding back output signal.

Effect and Battery Indicator

The ON/BATT LED indicates effect activation and battery level.

Footswitch Operation

Use the footswitch to activate or deactivate the effect.

Input and Output Connections

Connects instrument cable via 1/4" TS IN and sends signal to amp via 1/4" TS OUT.

Safety Instructions

Warranty Information