Behringer ULTRA FLANGER

To Next Page

COMPRESSOR SUSTAINER CS400

Thank you for showing your confidence in us by purchasing the BEHRINGER

COMPRESSOR SUSTAINER CS400. This ultimate effects pedal is specifically designed to

achieve super-smooth compression and endless sustain. Thanks to its high-performance

features you can compress loud and boost low signals without degrading the original

sound.

A compressor limits the dynamic range of a signal. This means that signal peaks will be

attenuated and the level differences between loudest and softest playing are reduced.

This results in a more powerful and pressure-rich tone.

1. CONTROLS

Top view

The LEVEL control adjusts the output level.

Turn up the TONE control to achieve more presence and sound clarity.

The ATTACK control determines how fast the compressor reacts on the input

signal. The attack time is sweepable between slow and fast.

The SUSTAIN control determines the amount of compression that results in long-

lasting tones.

The ON/BATT LED illuminates when the effect is activated. It also serves as a

battery level indicator.

Use the footswitch to activate/deactivate the effect.

Use this 1/4" TS IN connector to plug in the instrument cable.

The 1/4" TS OUT connector sends the signal to your amp.

Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).

The BATTERY COMPARTMENT is located underneath the pedal cover. To install or

replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be

careful not to scratch the unit.

Need help?

Do you have a question about the Behringer ULTRA FLANGER and is the answer not in the manual?

Summary

Controls Overview

LEVEL Control

Adjusts the output level of the signal.

TONE Control

Provides more presence and sound clarity.

ATTACK Control

Determines how fast the compressor reacts to the input signal.

SUSTAIN Control

Determines the amount of compression for long-lasting tones.

ON;BATT LED

Indicates when the effect is active and serves as a battery level indicator.

Footswitch

Activates or deactivates the effect.

IN Connector

1/4" TS connector to plug in the instrument cable.

OUT Connector

1/4" TS connector sends the signal to your amplifier.

DC IN Connection

Connects a 9 V power supply to the unit.

Battery Compartment

Located underneath the pedal cover for a 9 V battery.

WARRANTY

SPECIFICATIONS

SAFETY INSTRUCTIONS

General Safety Warnings

General warnings regarding water, heat sources, authorized accessories, and self-servicing.