Behringer SUPER FUZZ SF300 - User Manual

SUPER FUZZ SF300
Thank you for showing your confidence in us by purchasing the BEHRINGER SUPER
FUZZ SF300. This effects pedal is ideally suited for electric guitars and recreates the
whole variety of famous fuzz tones of the '60s and '70s.
1. CONTROLS
Top view
The LEVEL control adjusts the output level.
The TREBLE control allows you to boost/cut the high-frequency range.
The BASS control allows you to boost/cut the low-frequency range.
The GAIN control adjusts the gain for more distorted sounds.
The MODE switch lets you choose between 3 effect modes.
FUZZ 1: Basic fuzz sound with emphasis on the midrange.
FUZZ 2: Full-bodied fuzz sound with scooped mids and sharp harmonics.
BOOST: The LEVEL control is inactive and the GAIN control adjusts the boost.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove
the pedal cover. Be careful not to scratch the unit.
 The SF300 has no on/off switch. As soon as you insert the plug into the IN
connector, the SF300 is on. When not in use, remove the plug from the IN
connector. This extends the life of the battery.

Behringer SUPER FUZZ SF300 Specifications

Power

power supply voltage	9 V
power supply current	100 mA
power consumption	30 mA

Input and Output

input connector	1/4" TS
input impedance	500 kΩ
output connector	1/4" TS

Weight and Dimensions

weight	0.33 kg
height	54 mm
width	70 mm

Summary

Pedal Controls

LEVEL Control

Adjusts the output level of the effect pedal.

TREBLE Control

Adjusts the high-frequency range, allowing boost or cut.

BASS Control

Adjusts the low-frequency range, allowing boost or cut.

GAIN Control

Adjusts the gain for more distorted sounds.

MODE Switch

Selects between three effect modes: FUZZ 1, FUZZ 2, and BOOST.

ON;BATT LED

Indicates effect activation and serves as a battery level indicator.

Effect Footswitch

Activates or deactivates the effect pedal.

Input;Output Connectors

1/4" TS IN connector for instrument cable and 1/4" TS OUT for amplifier.

Power and Battery Management

Details DC IN connection, battery compartment, and auto-on usage for battery life.

Warranty Information

Technical Specifications

Safety Instructions