3. Make all necessary connections. DO NOT turn on the power yet.
4. Turn on your audio sources (mixer, microphones, instruments).
5. Turn on your speaker(s) by pressing the POWER switch. The PWR LED will light up.
6. Insert your USB device or SD/MMC flash memory card with digital audio files into their respective USB or
SD/MMC connections.
7. Using the controls in the DSP section, choose a digital audio file from your USB stick or SD/MMC card and begin
playback by pressing the PLAY PAUSE button.
8. Turn the LEVEL control up to around the 50% position.
9. Make overall volume adjustments using the MASTER knob.
10. Play your analog audio sources, or speak into your microphone at a normal to loud level.
11. Balance the analog signals against the digital audio playback by adjusting the LEVEL knob and the volume
knobs on each analog channel. If an analog signal distorts, turn that analog channel’s volume knob back down.
If necessary, adjust the HIGH and LOW EQ knobs to boost or cut treble and bass frequencies to your taste.
Specifications
Amplifier
Maximum output power* 200 W
Type Class-D
Speaker
Woofer 1 x 8″ (200 mm) LF driver
To Next Page
Loading...
