DIGITAL SNAKE SD16/SD8 Quick Start Guide
DIGITAL SNAKE SD16/SD8 Controls
(5)
(6)
(5)
(6)
(3) (4)
(3) (4)
(7)
(7)
(2)
(1)
(2)
(8)
(1)
(EN)
Step 2: Controls
(1)
MIDAS
-designed mic/
line combo inputs accept
balanced XLR and ¼
"
male
plugs. Channel 15 and 16
on the SD16 and channel 7
and 8 on the SD8 accept
high impedance signals for
direct connection of guitars
and basses.
(2)
XLR
outputs accept balanced
XLR female plugs.
(3)
POWER LED
lights when the
unit is powered on.
(4)
AES50 LEDs
light green
when the corresponding
AES50 port is connected
and synchronized, and light
red when connected but
not synchronized.
(5)
ULTRANET
ports allow
direct connection of up to
4 (SD16) or 2 (SD8) P16-M
personal mixers. The ports
provide phantom power,
allowing the P16-M units to
operate without additional
power supplies.
(6)
USB
port can be used to
connect a PC for updating
the firmware.
(7)
AES50
ports provide
connection between the
stage box and an X32 series
mixer, and also allows
other SD16/SD8 units to be
daisy chained. Port A should
be used to connect the X32
and additional stageboxes
can be daisy chained via
port B. See ‘Step 3: Channel
Management’ for details.
(8)
OUTPUT
select switch
determines which group of
8 AES50-A channels appear
at the physical XLR output
jacks. When using multiple
stage boxes, this allows
different output signals to
be sent to each unit.
(9)
POWER
switch turns the
unit on and off.
(8)
DIGITAL SNAKE SD16/SD8 15 Quick Start Guide
To Next Page
Loading...
