OVERDRIVE/DISTORTION OD300
2-Mode Overdrive/Distortion Eects Pedal
Thank you for showing your condence in us by purchasing the BEHRINGER OVERDRIVE DISTORTION OD300.
This eects pedal is ideally suited for electric guitars. Thanks to its high-performance features you can
create state-of-the-art overdrive, distortion or a combination of both eects.
1. Controls
(1) The LEVEL control adjusts the output level.
(2) The TONE control allows you to shape your overall sound.
(3) The DRIVE control adjusts the intensity of the overdrive/distortion eect.
(4) Use the MODE control to adjust the balance between overdrive and distortion eect. In leftmost
position you got pure overdrive eect and in the rightmost position you get pure distortion.
(5) The ON/BATT LED illuminates when the eect is activated. It also serves as a battery level indicator.
(6) Use the footswitch to activate/deactivate the eect.
(7) Use this ¼" TS IN connector to plug in the instrument cable.
(8) The ¼" TS OUT connector sends the signal to your amp.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery,
press the hinges with a ballpen and remove the pedal cover. Be careful not to scratch the unit.
◊ The OD300 has no on/o switch. As soon as you insert the jack into the in connector,
the OD300 begins running. When not using the OD300, remove the jack from the
in connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.
(5)
(1)
(8)
(6)
(3)(2)
(4)
(7)
To Next Page
Need help?
General
