Behringer DIGITAL REVERB DR600

To Next Page

DIGITAL REVERB DR600

Thank you for showing your confidence in us by purchasing the BEHRINGER DIGITAL

REVERB DR600. This ultimate effects pedal is specifically designed to deliver 24-bit high-

resolution stereo reverbs comparable to state-of-the-art studio processors. Thanks to

six renowned modes and extensive parameter control for maximum creativity you’ll have

plenty of cool sounds at your disposal for every situation.

1. CONTROLS

Top view

The LEVEL control adjusts the output level.

The TONE control allows you to shape your overall sound.

The TIME control determines the reverb time.

The MODE control lets you chose between six different reverb sounds:

SPRING: Simulates classic spring reverberation.

PLATE: Simulates the sound of plate reverberation.

HALL: Very bright reverb that simulates the reflections of a concert hall.

GATE: This effect synthetically cuts off reverberation after a period of time.

ROOM: Clearly hear natural room acoustics.

MODULATE: By detuning the reverb tail it creates spacious, almost choir-like

reverb that reminds a little bit of a chorus effect.

The ON/BATT LED illuminates when the effect is activated. It also serves as a

battery level indicator.

Use the footswitch to activate/deactivate the effect.

Use the two 1/4" TS connectors IN A and IN B to plug in a stereo input signal. For

mono use just plug in IN A.

The two 1/4" TS connectors OUT A and OUT B send the signal to your amp. Use both

connectors if you want to achieve full stereo effect. For mono use just plug in OUT A.

Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).

The BATTERY COMPARTMENT is located underneath the pedal cover. To install or

replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be

careful not to scratch the unit.

 The DR600 has no on/off switch. As soon as you insert the jack into the IN

connector, the DR600 begins running. When not using the DR600, remove

the jack from the IN connector. This extends the life of the battery.

The SERIAL NUMBER is located at the bottom.

Other manuals for Behringer DIGITAL REVERB DR600

Manual24 pages

Need help?

Do you have a question about the Behringer DIGITAL REVERB DR600 and is the answer not in the manual?

Summary

CONTROLS

LEVEL Control

Adjusts the output level of the effect.

TONE Control

Shapes the overall sound character of the reverb.

TIME Control

Determines the duration of the reverb effect.

MODE Control

Selects between six different reverb sound modes.

ON;BATT LED Indicator

Indicates effect activation and battery level.

Footswitch Operation

Activates or deactivates the effect.

Input Connectors

For stereo (IN A/IN B) or mono (IN A) input signal.

Output Connectors

For stereo (OUT A/OUT B) or mono (OUT A) output.

WARRANTY

SPECIFICATIONS

SAFETY INSTRUCTIONS

FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION