Behringer HEAVY DISTORTION HD300 - User Manual

HEAVY DISTORTION HD300
Thank you for showing your confidence in us by purchasing the BEHRINGER HEAVY
DISTORTION HD300. This high-quality effects pedal enables you to produce super thick,
tube-like distortion plus endless sustain. Thanks to its high-performance features you
can achieve the typical hard rock or heavy metal distortion sounds, when playing over
a clean amp channel.
1. CONTROLS
Top view
The LEVEL control adjusts the output level.
The TONE control allows you to shape your overall sound.
The BOTTOM control allows you to boost/cut the low-frequency range.
The DIST(ortion) control adjusts the amount of distortion.
The GAIN BOOST control adjusts the gain for more extreme distortion sounds.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove
the pedal cover. Be careful not to scratch the unit.
 The HD300 has no on/off switch. As soon as you insert the plug into the IN
connector, the HD300 is on. When not in use, remove the plug from the IN
connector. This extends the life of the battery.

Behringer HEAVY DISTORTION HD300 Specifications

Inputs and Outputs

input connector type	1/4" TS
input impedance	500 kΩ
output connector type	1/4" TS
output impedance	1 kΩ

Power

power supply voltage	9 V
power supply current	100 mA regulated
battery type	9 V type 6LR61
power consumption	30 mA

Weight and Dimensions

height	54 mm
width	70 mm
depth	123 mm
weight	0.33 kg

Summary

CONTROLS

Effect and Tone Controls

Controls for LEVEL, TONE, BOTTOM, DIST(ortion), and GAIN BOOST.

Indicators and Footswitch

Details the ON/BATT LED and the footswitch for effect activation.

Input;Output Connections

Describes the 1/4" TS IN and 1/4" TS OUT connectors.

Power and Battery Management

Covers DC IN connection, battery compartment, and power on/off behavior.

WARRANTY

Warranty Information

Details current warranty terms available on the Behringer website.

SPECIFICATIONS

Technical Specifications

Covers input/output connectors, impedance, power supply, battery, dimensions, and weight.

SAFETY INSTRUCTIONS

General Safety Precautions

Advises against water, heat, and unauthorized servicing.

Technical Disclaimer

States specifications may change without notice and limits liability.