Behringer Heavy Metal HM300

To Next Page

HEAVY METAL HM300

Heavy Metal Distortion Eects Pedal

Thank you for showing your condence in us by purchasing the BEHRINGER HEAVY METAL HM300.

This high-quality eects pedal enables you to produce super thick, tube-like distortion plus endless

sustain. Thanks to its high-performance features you can achieve the typical hard rock or heavy metal

distortion sounds.

1. Controls

(1) The LEVEL control adjusts the output level.

(2) The LOW control allows you to boost/cut the low-frequency range.

(3) The MID control allows you to boost/cut the mid-frequency range.

(4) The DIST control adjusts the amount of distortion eect and the length of the resulting sustain

time. High distortion settings will cause longer sustain times.

(5) The ON/BATT LED illuminates when the eect is activated. It also serves as a battery level indicator.

(6) Use the footswitch to activate/deactivate the eect.

(7) Use this ¼" TS IN connector to plug in the instrument cable.

(8) The ¼" TS OUT connector sends the signal to your amp.

Use the DC IN connection to plug in a 9 V power supply (not included).

The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery

(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to

scratch the unit.

◊ The HM300 has no on/o switch. As soon as you insert the plug into the in connector,

the HM300 is on. When not in use, remove the plug from the in connector. This extends

the life of the battery.

The SERIAL NUMBER is located at the underside.

(5)

(1)

(8)

(6)

(7)

(3)(2)

(4)

Other manuals for Behringer Heavy Metal HM300

User Guide2 pages

Quick Start Guide2 pages

Manual24 pages

Need help?

Do you have a question about the Behringer Heavy Metal HM300 and is the answer not in the manual?

Summary

Controls Overview

Main Tone Controls

Adjusts output level, low/mid frequencies, and distortion amount for tone shaping.

Effect Status and Activation

Features ON/BATT LED for status and a footswitch to toggle the effect on/off.

Connectivity and Power

Details 1/4" IN/OUT jacks, DC power input, and battery operation.

Serial Number Location

Indicates the location of the unit's serial number for reference.

Safety Instructions

Warranty Information

Technical Specifications