Behringer DIGITAL DELAY DD600 User Manual

DIGITAL DELAY DD600
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the foot switch to activate/deactivate the effect. In HOLD mode, use the foot
switch to start and stop the recording. The signal is recorded while holding down
the foot switch. Playback begins immediately after releasing it.
MODE Effect description D.TIME
1
Short delay 1 - 50 ms
2
Short to medium delay 50 - 200 ms
3
Medium to long delay 200 - 800 ms
4
Long delay 800 - 2000 ms
5HOLD
Record and play back your performance (Rec. time: max. 2 s)
6 REVERSE
Signal is repeated in reverse 1000 - 2000 ms
7E/D
Stereo delay using OUT A and PAN OUT 1 - 400 ms
8
Adds a quarter note
9
Adds an eighth note
10
Adds a dotted eighth note
11
Adds a triplet
TEMPO
D.TIME disabled.
Tap tempo via
external foot switch
DELAY
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove
the pedal cover. Be careful not to scratch the unit.
 The DD600 has no On/Off switch. It is operable as soon as you insert a
plug into the IN connector. Disconnect the plug, if you don’t use the
DD600. In doing so, you can extend the life time of the battery.
Thank you for showing your confidence in us by purchasing the BEHRINGER DIGITAL
DELAY DD600. This digital Delay effects pedal is designed to deliver 24-bit high-resolution
stereo delay sounds comparable to state-of-the-art studio processors. Thanks to its parameter
controls, you’ll have plenty of cool sounds at your disposal to handle every situation.
1. CONTROLS
Top view
Select the effect mode via the MODE
switch (see table below).
Use the D.TIME control to fine-tune the
delay time. The delay time describes how
fast the signal repetitions will follow
after the original signal. Depending on
the selected mode, you can adjust it
between 1 ms and 2000 ms. In HOLD
and TEMPO modes, D.TIME is disabled.
The F.BACK (feedback) control adjusts
the amount of signal repetitions. In
HOLD mode, F.BACK is disabled.
LEVEL adjusts the effect level.
Use the ¼" TS IN connector to plug in
the instrument cable.
Use the ¼" TS TEMPO connector to
connect an external foot switch.
Use the foot switch to tap in the song
tempo (in TEMPO MODE).
The ¼" TS OUT A connector sends a
mono signal to your amp. In E/D mode,
it sends the effect signal only.
Use the PAN OUT connector and OUT
A to acheive a full stereo delay effect.
In E/D mode, it sends the dry signal only.

Behringer DIGITAL DELAY DD600 Specifications

Power

power supply voltage	9 V
power supply current	100 mA
power consumption	70 mA

Ports & Interfaces

input connector	1/4" TS, 500 kΩ
tempo connector	1/4" TS, 500 kΩ
output A connector	1/4" TS, 500 kΩ

Weight and Dimensions

height	54 mm
width	70 mm
depth	123 mm
weight	0.33 kg