behringer.com
Stompbox Accessories
PEDAL BOARD
PB600
Pedal Board with 9 V DC Power Supply
and Patch Cables
* Depends on the power consumption
of the e ects pedals, etc.
Ultra-compact and lightweight
pedal board for transporting up
to 6 e ects pedals, including
patch cables
Generous 1.7 A power adapter
included for powering more
than 12 devices*—includes
1 x 6 daisy-chain cabling
Ultra-rigid plastic design withstands
even heavy impact
High-quality components and
exceptionally rugged construction
ensure long life
Conceived and designed by
BEHRINGER Germany
When e ects are an integral part of your
rig, their power adapters and patch cables
can often be the most vulnerable part, and
the most likely to sabotage your set if
they're not pampered. Rather than tossing
your pedals, power adapters and all
other cabling into a du el bag after a gig,
keep them safe—and ready to rock at a
moment’s notice—with the PB600.
It's all about connections
This awesome pedal board makes
hooking up six 2.5" x 4.5" pedals as easy
as hooking up just one (of course, if
you're using pedals that aren’t 2.5" x 4.5",
the snug foam padding can be cut to
accommodate pedals of varying shapes).
The PB600 includes ¼" patch cables, so you
can leave your pedals connected to one
another, ready to pass signal even when
you’re transporting them. It also comes
with 1 x 6 daisy chain cabling so that when
you plug in the 1.7 A power adapter, all
your pedals receive power. Meanwhile,
all cabling remains safe and free of strain.
Failure is almost guaranteed when you’re
dealing with a rat’s nest of loose cabling,
but with the PB600, your e ects chain is
always safe and organized.
Connect your guitar, bass or keyboard
to the single ¼" input in the upper right
corner of the board. A pair of ¼" FROM
EFFECTS jacks in the upper left corner
allow you to connect stereo e ects, and
two ¼" OUTPUT TO AMP jacks send a left
and right stereo signal to up to two amps.
Continued on next page
To Next Page
Need help?
General
