Behringer PHASER PH9 - User Manual

PHASER PH9
Thank you for showing your confidence in us by purchasing the BEHRINGER PHASER PH9. This
ultimate effects pedal is designed for all musicians longing for a way to pep up their sound.
Thanks to its high-performance features, you can create phase-shifting effects with different
characteristics ranging from modern to vintage.
With the phaser, a second phase-shifted signal is added to the original audio of your instrument.
The resulting sound is thicker and above all livelier. Nowadays, this effect is often used for guitar
sounds and keyboards, but it was also extensively used for other instruments like electric
pianos in the ‘70s.
1. CONTROLS
Top view
The RATE control determines the speed of the phase-shifting effect, in other words the
overall effect rate.
The SWIRL switch changes the phaser character from modern (upper position) to vintage
(lower position).
The LED illuminates when the effect is activated. It also serves as a battery level indicator.
Depress the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
To install or replace the 9 V battery, remove the bottom side of the unit taking the four screws off.
 The PH9 has no on/off switch. As soon as you connect the jack to the IN connector,
the PH9 is switched on. When the PH9 is not being used, remove the jack from
the IN connector to extend the battery life.
The SERIAL NUMBER is located on the bottom side of the device.
2. WARRANTY
For our current warranty terms, please refer to our website at http://www.behringer.com.

Behringer PHASER PH9 Specifications

Connectivity

input connector	1/4" TS
output connector	1/4" TS
power connector	2 mm DC jack, negative center

Impedance

input impedance	1 MΩ
output impedance	1 kΩ

Power

power supply	9 V, 100 mA regulated
battery type	9 V type 6LR61
power consumption	10 mA

Voltage

voltage USA/Canada	120 V~, 60 Hz
voltage Europe/U.K./Australia	230 V~, 50 Hz
voltage China/Korea	220 V~, 50/60 Hz

Weight and Dimensions

height	56 mm (2 1/5")
width	113 mm (4 2/5")
depth	69 mm (2 2/3")
weight	0.24 kg (0.53 lbs)

Summary

PHASER PH9 Controls

RATE Control

Determines the speed of the phase-shifting effect.

SWIRL Switch

Changes the phaser character between modern and vintage modes.

LED Indicator

Indicates effect activation and battery level.

Footswitch Operation

Activates or deactivates the effect by depressing it.

Input Connector

1/4" TS IN connector for instrument cable input.

Output Connector

1/4" TS OUT connector for sending signal to amplifier.

Power and Battery Management

Details DC IN connection, battery replacement, and automatic power on/off.

Warranty Information

Product Specifications

Safety Instructions