Behringer PRO-1 - Audio and Headphone Outputs; PHONES >; AUDIO OUT >; Top Panel Electrical Reference

AP099
Revision 1.01
CM100B
PHONES >
A stereo 3.5mm headphone socket. Headphone impedance should be no less than 600
ohms.
AUDIO OUT >
Mono 3.5mm output of the Pro-1. This is functionally the same as the 6.35mm OUTPUT socket
on the rear of the unit. This is a high impedance line level output and should be connected to
a mixer, audio interface or to an amplifier. DO NOT connect it directly to speakers.
Top Panel Electrical Reference
Input
Input or
Output
Electrical specification
MOD WH CV
Input
0V to +5V
OSC CV
Input
-5V to +5V
GATE/CLK
Input
>2V to trigger
LFO CV
Input
-5V to +5V
LFO OUT
Output
Triangle +/-2.5V, Pulse +4V, Sawtooth +5V
KYBD CV
Output
0V to +7V
GATE
Output
0V or +5V
EXT
Input
Impedance 85KΩ
MIXER
Output
Unbalanced max +20dBu
CUTOFF CV
Input
0V to +5V
RESO CV
Input
0V to +5V
FILTER ENV
Output
0V to +5V
AMP ENV
Output
0V to +5V
PHONES
Output
Signal output
AUDIO OUT
Output
Signal output
Page of 22 34