Behringer Spectrum Enhancer SE200 User Guide

SPECTRUM ENHANCER SE200
Thank you for showing your confidence in us by purchasing the BEHRINGER SPECTRUM
ENHANCER SE200. This miracle box enhances the sound of almost any instrument by
emphasizing the instrument’s tone spectrum.
1. CONTROLS
Top view
The BALANCE control adjusts the relation between direct and effect signal.
The SPECTRUM control adjusts the center frequency of the range that will be
emphasized from 500 Hz to 5 kHz.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove
the pedal cover. Be careful not to scratch the unit.
 The SE200 has no on/off switch. As soon as you insert the plug into the IN
connector, the SE200 is on. When not in use, remove the plug from the IN
connector. This extends the life of the battery.
The SERIAL NUMBER is located at the underside.

Behringer Spectrum Enhancer SE200 Specifications

Input Specifications

input connector	1/4" TS
input impedance	500 kΩ

Output Specifications

output connector	1/4" TS
output impedance	1 kΩ

Power

power supply	9 V, 100 mA regulated
battery	9 V type 6LR61
power consumption	30 mA

Power Supply by Region

power supply USA/Canada	120 V~, 60 Hz
power supply Europe/U.K./Australia	230 V~, 50 Hz
power supply China	220 V~, 50 Hz

Weight and Dimensions

dimensions	54 mm x 70 mm x 123 mm
weight	0.33 kg