Behringer Spectrum Enhancer SE200 User Manual

SPECTRUM ENHANCER SE200
Sound Enhancement Eects Pedal
Thank you for showing your condence in us by purchasing the BEHRINGER SPECTRUM ENHANCER SE200.
This miracle box enhances the sound of almost any instrument by emphasizing the instrument’s
tone spectrum.
1. Controls
(1) The BALANCE control adjusts the relation between direct and eect signal.
(2) The SPECTRUM control adjusts the center frequency of the range that will be emphasized
from 500 Hz to 5 kHz.
(3) The ON/BATT LED illuminates when the eect is activated. It also serves as a battery level indicator.
(4) Use the footswitch to activate/deactivate the eect.
(5) Use this ¼" TS IN connector to plug in the instrument cable.
(6) The ¼" TS OUT connector sends the signal to your amp.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the
9 V battery, press the hinges with a ballpen and remove the pedal cover. Be careful not to scratch
the unit.
◊ The SE200 has no on/o switch. As soon as you insert the plug into the in connector,
the SE200 is on. When not in use, remove the plug from the in connector. This extends
the life of the battery.
The SERIAL NUMBER is located at the underside.
(1)
(6)
(3)
(2)
(5)
(4)

Behringer Spectrum Enhancer SE200 Specifications

Input Specifications

input connector	1/4" TS
input impedance	500 kΩ

Output Specifications

output connector	1/4" TS
output impedance	1 kΩ

Power

power supply	9 V, 100 mA regulated
battery	9 V type 6LR61
power consumption	30 mA

Power Supply by Region

power supply USA/Canada	120 V~, 60 Hz
power supply Europe/U.K./Australia	230 V~, 50 Hz
power supply China	220 V~, 50 Hz

Weight and Dimensions

dimensions	54 mm x 70 mm x 123 mm
weight	0.33 kg

Summary

Controls Overview

User Interface Controls

Details on BALANCE, SPECTRUM knobs, ON/BATT LED, and footswitch for effect operation and status indication.

Connectivity and Power Management

Explains 1/4" TS input/output jacks, DC power input, battery compartment access, and automatic power on/off.

Safety Instructions

General Safety Precautions

Advises against use near water, heat sources, unauthorized servicing, and specifies using qualified personnel for repairs.

Warranty Information

Product Registration

Instructions to register new BEHRINGER equipment on behringer.com to review warranty terms and conditions.

Technical Specifications

Connectivity and Power Specs

Details input/output connectors, impedance, power supply requirements, and power connector type.

Physical Dimensions and Weight

Provides the physical size (H x W x D) and weight of the SPECTRUM ENHANCER SE200 pedal.

Battery and Power Consumption

Specifies the type of battery used (9 V type 6LR61) and the unit's power consumption.