Behringer SUPER-X PRO - Stereo 2-Way Operation; Front Panel Controls Overview; Rear Panel Connections Overview

3
SUPER-X PRO CX2310
1
INPUT control. This control adjusts the input gain over the range from -12 to + 12 dB.
LOW CUT switch. This switch activates the 25 hz high-pass lter. It has a side gradient of 12 dB/octave and is used to
protect your bass loudspeaker.
LOW/HIGH XOVER FREQ. control. This control governs the crossover frequency between the low and high bands.
LOW OUTPUT control. Controls the output level of the low band over the range from -6 to + 6 dB.
LOW PHASE INVERT switch. This switch reverses the polarity of the low output.
LOW MUTE switch. This is used to mute the low band.
HIGH OUTPUT control. This controls the output level of the high band over the range from -6 to + 6 dB.
HIGH PHASE INVERT switch. his switch reverses the polarity of the highoutput.
HIGH MUTE switch. This is used to mute the high band.
XOVER FREQ. control. This control governs the crossover frequency between the low signal and the subwoofer
signal (10 to 235 hz).
GAIN control. This is used to set the subwoofer output volume.at the SUBW. OUT output,
PHASE INVERT switch. This switch reverses the polarity of the subwoofer output signal.
MUTE switch. This mutes the subwoofer output signal.
2
3
4
5
6
7
8
9
10
11
12
13
2.1 Stereo 2-Way Operation with separate subwoofer signal
First, activate the 2-way mode using the MODE switch on the rear panel (switch depressed). The STEREO LED on the front
panel above the LOW CUT switch in the second channel lights up.
The LED is above the active control on the front panel that lights up. They show you which controls are active for the mode of
operation which you have selected. The function of these controls can be seen from the second strip label. In stereo operation
the functions of both channels are identical, so that the numbers on the overview are shown for only one channel.
Fig. 2.1: Active control elements on the front panel of the SUPER-X PRO
in stereo 2-way operation wtih separate signal subwoofer.
Fig. 2.2: Active control elements and connections on the rear panel of the SUPER-X PRO
in stereo 2-way operation wtih separate signal subwoofer.