3. INPUT: These are the balanced inputs of your TRUTH, laid out as 1/4″ TRS and XLR connectors.
4. The mains connection is achieved via the standard IEC connector. A matching power cord is included.
5. FUSE COMPARTMENT/VOLTAGE SELECTION.
6. Use the POWER switch to power up your TRUTH. The POWER switch should always be in the “Off” position
when you are about to connect your unit to the mains.
7. INPUT TRIM: Use this control to adapt the TRUTH’s input sensitivity to the signal source.
8. LOW FREQUENCY: With this switch you can adapt the woofer to a subwoofer system or emulate the sound
characteristics of small speaker systems.
9. ROOM COMPENSATION: For maximum flexibility the TRUTH features a switch that adjusts the speaker
depending on its setup position.
10. HIGH FREQUENCY: This switch adapts the speaker’s frequency response to the damping characteristics of the
control room.
11. POWER MODE: This switch allows you to toggle between “ON”, “OFF” and “AUTO” power-up modes.
12. MUTE LOW: Disables the woofer for servicing and maintenance.
13. MUTE HIGH: Disables the tweeter for servicing and maintenance.
Specifications
XLR connector servo-balanced input
1/4″ TRS servo-balanced input
Input impedance 10 kΩ
Max. input level +22 dBu
Tweeter 1″ ferrofluid-cooled dome ¾” ferrofluid-cooled dome
Woofer 8 ¾” polypropylene diaphragm 6 ¾” polypropylene diaphragm
RMS @ 0.1 % THD 140 W 70 W
Peak power 265 W 125 W
To Next Page
Loading...
