Behringer Ultra-G GI100 - Controls

12 13ULTRA-G GI100 Quick Start Guide
ULTRA-G GI100 Controls
(EN) Controls
(1) The VIRTUAL 4 x 12" CAB speaker simulation
can be switched on and o with the
SIMULATOR ON/OFF switch.
(2) When activated, the GND LIFT breaks the
ground connection between input and
output. Depending on the grounding of the
connected equipment, thiscan eliminate
hum or ground loops.
(3) OUTPUT TO MIXER is the GI100’s balanced,
mic level output. Useahigh-quality,
balancedXLR (microphone) cable to connect
the ULTRA-G toaconsole.
(4) BATTERY COMPARTMENT. To install or
replace the 9V battery, remove the screw
and lift the lid.
(5) The CLIP LED lights up when the input signal
level is too high.
(6) The two -20 dB PAD switches noticeably
increase the operating range of the ULTRAG,
allowing it to accept anything from the
low-level signal of a high-impedance
microphone or guitar to the loudspeaker
output of a guitar amp. These switches
have repeatedly proven themselves in the
BEHRINGER ULTRA-DI DI100. Pressing both
switches results in a gain reduction of 40 dB.
(7) INPUT. Use this ¼ " mono jack to
connect the signal source, e.g. your
guitar, with a high-quality standard
instrumentcable.
(8) The DIRECT LINK TO CABINET is a direct
output of the input signal, allowingyou
for example to simultaneously run your
instrument through theGI100 and complete
your normal signal path by connecting the
DIRECTLINK to an amp or speaker cabinet.
(8)(7)
(5)
(1)
(2) (3) (4)
(6)