What to do if the Beko Water Filtration Systems device blows off continuously?
If your Beko Water Filtration System is blowing off continuously, the service unit may be defective or dirty. Replace the service unit to resolve this issue.
What to do if the test button is pressed, but no condensate discharges from my Beko Water Filtration Systems?
If pressing the test button on your Beko Water Filtration System doesn't result in condensate discharge: 1. Check the feed and discharge pipes for any blockages or obstructions. 2. Test the valve by pressing the test button several times for more than 2 seconds to check if it opens audibly. This helps determine if wear and tear is the issue. 3. Inspect the circuit board for possible damage. 4. Check the operating pressure of the service unit.
Why is the LED continuously orange on my Beko BEKOMAT 31U Water Filtration Systems?
If the LED on your Beko Water Filtration System lights up continuously orange, it could indicate: * A failure during the start of the program. To resolve this, separate the device from the supply voltage and reactivate it after more than 5 seconds. * A defective circuit board. Inspect the circuit boards for any signs of damage.
How to fix condensate discharge only when the test button is pressed on Beko Water Filtration Systems?
If condensate discharges from your Beko Water Filtration System only when the test button is pressed: * Ensure the feed pipe is installed with a sufficient slope. * Replace the service unit, as it may be extremely dirty.
How to troubleshoot if the LED does not light up on Beko BEKOMAT 31U?
If the LED on your Beko Water Filtration System does not light up, check the following: 1. Verify the supply voltage matches what is indicated on the type plate. 2. Inspect the circuit boards for any signs of damage.
General| Brand | Beko |
|---|---|
| Model | BEKOMAT 31U |
| Category | Water Filtration Systems |
| Language | English |
To Next Page
