Beko BFC60EMW - Product Safety

• The product must be unplugged
during installation, maintenance,
cleaning and repairing procedures.
• If the power connection cable for
the product is damaged, it must
be replaced by the manufacturer,
its service agent or similarly
qualified persons in order to avoid
a hazard.
• Only use the connection cable
specified in the "Technical
specifications".
• The appliance must be installed
so that it can be completely
disconnected from the network.
The separation must be provided
either by a mains plug, or a
switch built into the fixed
electrical installation, according to
construction regulations.
• If the electrical supply is re-
stricted, means of all-pole dis-
connection must be accessible
and incorporated in the fixed wir-
ing in accordance with the wiring
rules.
• Rear surface of the oven gets hot
when it is in use. Make sure that
the electrical connection does not
contact the rear surface;
otherwise, connections can get
damaged.
• Do not trap the mains cable
between the oven door and frame
and do not route it over hot
surfaces. Otherwise, cable
insulation may melt and cause
fire as a result of short circuit.
• Any work on electrical equipment
and systems should only be
carried out by authorized and
qualified persons.
• In case of any damage, switch off
the product and disconnect it
from the mains. To do this, turn
off the fuse at home.
• Make sure that fuse rating is
compatible with the product.
Product safety
• WARNING: In order to prevent
accidental tipping of the
appliance, for example by a child
climbing onto the open oven door,
the stabilizing means must be
installed. Please refer to
instructions for installation.
• If this appliances is installed on a
base, measures must be taken to
prevent the appliance from slip-
ping from the base
• Never use the product when your
judgment or coordination is
impaired by the use of alcohol
and/or drugs.
• Be careful when using alcoholic
drinks in your dishes. Alcohol
evaporates at high temperatures
and may cause fire since it can
ignite when it comes into contact
with hot surfaces.
• Do not place any flammable
materials close to the product as
5/EN