Beko CEG5331X - Page 37

37 / EN
Fully Automatic Coffee Machine / User Manual
Problem Cause Solution
No mlk foam out from the
machne
The hole of Mlk tube connector
s blocked by mlk resdues
Refer to secton “Daly Cleanng
of the applance” ,follow
“cleanng the mlk contaner
and connecton mlk tube”,
Clean the connector and
make sure all the hole on the
connector s clean, use needle
or brstle of brush to clean the
hole.
The hole of Mlk tube connector
s blocked by mlk resdues
whch hardly to be cleaned
The mlk tube connector not be
cleaned for a long tme
Soakng the connecton mlk
tube nto warm water for an
hour, follow the “cleanng the
mlk contaner and connecton
mlk tube” n secton “Daly
Cleanng of the applance”,
keep usng frothng mlk
functon to clean untl
water come from dspenser
smoothly. Use needle or brstle
of brush to clean the hole
The mlk froth s of poor qualty The type of mlk used s not
sutable for frothng
Dfferent types of mlk result n
dfferent amounts of froth and
dfferent forth qualtes. Sem-
skmmed or full-fat cow’s mlk
gves good results.
The temperature of the mlk s
too hgh
No mlk foam out from the
machne
Mlk spray out the table Mlk dspensng tube s not put
n place
Mlk foam spray out from
dspenser
Descalng ndcator keep
flashng even after the
descalng process
Decalng process s not
completed
Please be patent and wat
for the process fnsh. The
machne wll auto shut off
automatcally , don’t swtch off
the machne manually
6
Troubleshootng