Beko DNE 65000 E - Filling in the water tank of water dispenser; Cleaning the water tank; Water tray

EN
11
Filling in the water tank of water
dispenser
Open the cap of the water tank as
illustrated in the figure. Fill in with pure
and clean drinking water. Close the cap.
Caution!
•Donotfillwatertankwith any liquid other
thandrinkingwater;beveragessuch
as fruit juice, carbonated fizzy soda
drinks, alcoholic drinks are not suitable
for use with water dispenser. If such
liquids are used, the water dispenser
will malfunction and may be damaged
beyond repair. The guarantee does
not cover such uses. Some chemical
ingredients and additives in such drinks
/beveragesmayalsoattackand
damage water tank material.
•Onlyusecleanpuredrinkingwater.
•Capacityofwaterdispensertankis2.2
litres [3.8 pints], do not overfill.
•Pushthewaterdispenserleverwith
a rigid cup. If you are using a plastic
disposable cup, then push the lever
with your fingers from behind the cup.
Cleaning the water tank
Remove the water tank, open the
latches on both sides and detach the
top cover mechanism from the water
tank. Clean the water tank with warm
clean water, reinstall the top cover
mechanism and fasten the latches.
When installing the water tank, make
sure that hooks behind it fits securely
into the hangers on the door. Make
sure that parts removed during cleaning
(if any) are installed correctly into their
original locations. Otherwise, water may
leak.
Important:
Water tank and components of water
dispenser are not dishwasher-proof.
Water tray
Water that drips while using the water
dispenser accumulates in the drip
tray. Remove the drip tray by pulling it
towards yourself and empty it from time
to time.
Remove the plastic drainer part as
shown in the diagram by pressing down
on the edge.
Remove the water valve from the water
tank as shown in the diagram. When
re-fitting, make sure the O-shaped seal
is in place.