Beko DNE 65000 E - Placing and assembly of your refrigerator; Preparation; Points to be considered when transporting the product

EN
5
Placing and assembly of your refrigerator
3
• Please remember that the
manufacturer shall not be held
liable if the information given in the
instruction manual is not observed.
This product is designed for
domestic use.
Points to be considered when
transporting the product:
1. Your refrigerator must be emptied and cleaned
prior to any transportation.
2. Shelves, accessories, crisper and etc. in your
refrigerator must be fastened securely by adhesive
tape against any jolt before repackaging.
3.Packagingmustbetiedwiththicktapesand
strong ropes and the rules of transportation
printed on the package must be followed.
Please remember…
Every recycled material is an indispensable source
for the nature and for our national resources.
If you wish to contribute to recycling the packaging
materials, you can get further information from the
environmental bodies or local authorities.
If the entrance door of the room where the
refrigerator will be installed is not wide enough
for the refrigerator to pass through, than call the
authorized service to have them remove the doors
of your refrigerator and pass it sideways through
the door.
1. Install your refrigerator to a place that allows
ease of use.
2. Keep your refrigerator away from heat sources,
humid places and direct sunlight.
3. There must be appropriate air ventilation around
your refrigerator in order to achieve an efficient
operation.
If the refrigerator is to be placed in a recess in the
wall, there must be at least 5 cm distance with the
ceiling and at least 5 cm with the wall.
If the floor is covered with a carpet, your product
must be elevated 2.5 cm from the floor.
4.Placeyourrefrigeratoronanevenfloorsurface
to prevent jolts.
5.Donotkeepyourrefrigeratorinambient
temperatures under 10°C.
Prior to operating your refrigerator, please
read the instruction manual carefully that
includes important information such as
installation, usage and maintenance of your
product.
Preparation
Your refrigerator should be installed at least 30
cm away from heat sources such as hobs, ovens,
central heater and stoves and at least 5 cm away
from electrical ovens and should not be located
under direct sunlight.
•Theambienttemperatureoftheroomwhereyou
install your refrigerator should at least be 10°C.
Operating your refrigerator under cooler conditions
than this is not recommended with regard to its
efficiency.
•Pleasemakesurethattheinteriorofyour
refrigerator is cleaned thoroughly.
•Iftworefrigeratorsaretobeinstalledsideby
side, there should be at least 2 cm distance
between them.
•Yourrefrigeratormustrunsmoothlywithout
any vibration. To ensure this, maintain the
balance of your refrigerator on the floor by
turning the adjustable front legs clockwise or
counterclockwise. This should be done before the
food is placed in the refrigerator.
•Whenyouoperateyourrefrigeratorforthefirst
time, please observe the following instructions
during the initial six hours.
- Temperature adjustment button should not
be turned off.
- The door should not be opened frequently.
- It must be operated empty without any food
in it.
 -Donotunplugyourrefrigerator;ifapower
failure occurs out of your control, please see the
warnings in section “Things to be done before
calling the authorized service”.
•Originalpackagingandfoammaterialsshouldbe
kept for future transportations or moving.