What to do if my Beko Washer does not drain water?
If your Beko Washer isn't draining water, the water drain hose might be clogged or twisted, so clean or flatten the hose. Alternatively, the pump filter might be clogged, so clean the pump filter.
What to do if my Beko Washer won't start after closing the door?
If your Beko Washer program doesn't start after closing the door, make sure you press the Start / Pause / Cancel button. Also, if you've loaded too much laundry, it may be difficult to close the door properly, so reduce the amount of laundry and ensure the door is closed correctly.
Why is there water leaking from the bottom of my Beko WITC 7612 B0W Washer?
If you notice water leaking from the bottom of your Beko Washer, it could be due to a clogged or twisted water drain hose. Clean or flatten the hose to resolve this. Another possible cause is a clogged pump filter, so clean the pump filter.
How to open the loading door of my Beko WITC 7612 B0W?
If the loading door of your Beko Washer cannot be opened: * If the door lock is activated because of the water level, drain the water by running the Pump or Spin programme. * If the machine is heating up the water or is at the spinning cycle, wait until the programme completes. * If the child lock is engaged, wait a couple of minutes for deactivation of the door lock. * If the door is stuck because of pressure, grab the handle and push and pull the loading door to release and open it.
What to do if my Beko Washer enters standby mode or does not take in water?
If your Beko Washer enters standby mode or doesn't take in water, check the following: * Ensure the tap is turned on. * Make sure the water inlet hose isn't bent; flatten it if it is. * Check if the water inlet filter is clogged and clean it if necessary. * Ensure the loading door is closed properly. * Verify the water connection. If water was cut off, press the Start/Pause key after the water supply is restored to resume operation.
What to do if my Beko WITC 7612 B0W Washer programme cannot be started or selected?
If the programme on your Beko Washer cannot be started or selected, the washing machine may have switched to self-protection mode due to a supply problem (line voltage, water pressure, etc.). To cancel the programme, turn the Programme Selection knob to select another programme. The previous programme will be canceled.
Why does my Beko Washer directly discharge the water it takes in?
If your Beko Washer directly discharges the water it takes in, the draining hose might not be at an adequate height. Connect the water draining hose as described in the operation manual.
Why is my Beko WITC 7612 B0W Washer vibrating and making noise?
Your Beko Washer might be vibrating or making noise due to several reasons: * The machine might be unbalanced, so adjust the feet to level it. * A hard substance might have entered the pump filter, so clean the pump filter. * The transportation safety bolts might not be removed, so remove them. * The laundry quantity might be too little, so add more laundry. * The machine might be overloaded, so take some laundry out or distribute the load evenly. * The machine might be leaning on something, so ensure it's not.
Why did my Beko WITC 7612 B0W stop shortly after the programme started?
If your Beko Washer stopped shortly after the programme started, it might have stopped temporarily due to low voltage. It will resume running when the voltage restores to the normal level.
Safety instructions to prevent injuries and material damage.
Safety guidelines for children's interaction with the product.
Precautions related to electrical hazards and proper connections.
Warnings about hot surfaces and keeping children away.
Product compliance with waste electrical and electronic equipment directive.
Information about recyclable packaging materials.
Instructions on selecting a suitable location for installation.
Steps to remove packaging reinforcement before installation.
Procedure for removing transportation safety bolts.
Instructions for connecting the water supply hose.
Steps for connecting the drain hose to a waste outlet.
Requirements for electrical connection and safety.
Steps for the first use of the washing machine.
Guidance on sorting laundry by fabric, colour, and soiling.
Instructions on preparing clothes and items for washing.
Tips for efficient and energy-saving washing practices.
How to load laundry correctly into the machine.
Information on maximum load capacity and its effect.
Explanation of the washing machine's control panel and buttons.
Steps to prepare the machine before starting a wash cycle.
Guidance on selecting programmes and efficient washing tips.
Overview of the primary washing programmes available.
Description of special programmes for specific needs.
Details on specific programmes like Rinse and Spin+Drain.
How to adjust the washing temperature.
How to select and adjust the spin speed.
How to select or cancel auxiliary functions.
Explains functions like Prewash, Fast+, and Extra Rinse.
How to activate Drum Cleaning and Child Lock.
How to set a delayed start for the washing programme.
Steps to start the selected washing programme.
How to follow the progress of a running programme.
Information about the door locking mechanism.
How to change settings or add/remove laundry during a programme.
How to cancel a running programme.
What happens at the end of a washing cycle.
Explanation of the machine's standby and energy-saving mode.
Instructions for cleaning the detergent dispenser drawer.
How to clean the loading door and the drum.
How to clean the exterior body and control panel.
Steps to clean the water intake filters.
Procedure for draining water and cleaning the pump filter.
General| Appliance placement | Built-in |
|---|---|
| Loading type | Front load |
| Product colour | White |
| Built-in display | Yes |
| Control type | Buttons, Rotary |
| Door hinge | Left |
| Drum material | Stainless steel |
| Inverter technology | Yes |
| Rated capacity | 7 kg |
| Maximum spin speed | 1200 RPM |
| Spin-drying class | B |
| Washing class | A |
| Number of washing programs | 15 |
| Delayed start timer | Yes |
| Energy Efficiency Class | A+++ |
| Water consumption per cycle | 45 L |
| Depth | 550 mm |
| Height | 820 mm |
| Water Consumption | 45 L |
| Delay Start | Yes |
| Child Lock | Yes |
| Type | Washer |
| Width | 60 cm |
To Next Page
