Why does my Beko WITV 8712 X0W discharge water immediately?
If your Beko washer immediately discharges the water it takes in, it might be because the draining hose is not at an adequate height. Connect the water draining hose as described in the operation manual.
What to do if my Beko WITV 8712 X0W does not drain water?
If your Beko washer is not draining water, the water drain hose might be clogged or twisted, so clean or flatten the hose. Alternatively, the pump filter might be clogged, so clean the pump filter.
What to do if Beko WITV 8712 X0W program does not start?
If the program on your Beko washer does not start after closing the door, ensure that you have pressed the Start / Pause / Cancel button. Also, if you have loaded too much laundry, it may be difficult to close the door properly. Reduce the amount of laundry and ensure the door is closed correctly.
Why is my Beko WITV 8712 X0W leaking water from the bottom?
If your Beko washing machine is leaking water, the water drain hose might be clogged or twisted, so clean or flatten the hose. Also, the pump filter might be clogged, so clean the pump filter.
Why is my Beko WITV 8712 X0W Washer not rinsing well?
Your Beko washer may not rinse well if the amount, brand, and storage conditions of the detergent used are inappropriate. Also, if detergent is put in the wrong compartment, the pump filter is clogged or the drain hose is folded. Use a detergent appropriate for the washing machine and your laundry. Keep detergents closed in an environment free of humidity and do not expose them to excessive temperatures. If detergent is put in the prewash compartment although the prewash cycle is not selected, the machine can take this detergent during rinsing or softener step. Put the detergent in the correct compartment. Check the filter. Check the drain hose.
What to do if my Beko WITV 8712 X0W Washer programme cannot be started?
If a programme cannot be started or selected on your Beko washing machine, the appliance may have switched to self-protection mode due to a supply problem (line voltage, water pressure, etc.). To cancel the programme, turn the Programme Selection knob to select another programme. The previous programme will be canceled.
Why is my Beko WITV 8712 X0W foam overflowing from the drawer?
Foam overflowing from the detergent drawer of your Beko washer is likely due to using too much detergent or the detergent having gotten damp. Mix 1 tablespoonful of softener and ½ l of water and pour it into the main wash compartment of the detergent drawer. Keep detergents closed in an environment free of humidity and do not expose them to excessive temperatures.
Why did the color of clothes fade in my Beko WITV 8712 X0W Washer?
The color of clothes faded in your Beko washer because excessive laundry was loaded in. Also, the detergent in use is damp, or a higher temperature was selected. Do not load the machine in excess. Keep detergents closed in an environment free of humidity and do not expose them to excessive temperatures. Select the proper programme and temperature according to the type and soiling degree of the laundry.
What to do if my Beko WITV 8712 X0W has too much foam?
If too much foam forms in your Beko washing machine, it may be due to using improper detergents, using an excessive amount of detergent, storing detergent improperly, washing meshed laundry, or putting detergent in the wrong compartment. Use detergents appropriate for washing machines, use only a sufficient amount of detergent, store detergent in a closed and dry location, use smaller amounts of detergent for meshed laundry, and put the detergent in the correct compartment.
Why does my Beko Washer have detergent residue in the drawer?
Detergent residue in the drawer of your Beko washer can occur if the detergent drawer is wet, so dry it before adding detergent. Also, the detergent may have gotten damp, so keep detergents closed in a dry environment. Low water pressure, blocked holes in the detergent compartment, a problem with the detergent drawer valves, or mixing softener with detergent can also cause residue. Check the holes and clean them if they are clogged. Do not mix the softener with detergent. Wash and clean the dispenser with hot water.
To Next Page
General
