Why can't I start or select a programme on my Beko WRE6511WBD Washer?
If the programme on your Beko Washer cannot be started or selected, it may be due to a supply problem such as line voltage or water pressure issues. To cancel the current programme, turn the Programme Selection knob to select another programme. This will cancel the previous selection.
What to do if laundry remains wet after Beko WRE6511WBD Washer programme?
If your laundry remains wet at the end of the Beko Washer programme, it could be due to excessive foam activating the automatic foam absorption system because of too much detergent. Try using the recommended amount of detergent. Alternatively, the machine might not switch to the spinning step if the laundry is not evenly distributed in the drum. In this case, rearrange the laundry and re-spin it.
What to do if my Beko WRE6511WBD Washer stopped shortly after the programme started?
If your Beko Washer stopped shortly after the programme started, it might have paused temporarily due to low voltage. The machine will resume running when the voltage returns to the normal level.
Why is my Beko WRE6511WBD Washer vibrating or making noise?
If your Beko Washer vibrates or makes noise, several factors could be the cause. First, ensure the machine is standing balanced by adjusting the feet. Check the pump filter for any hard substances and clean it if necessary. Make sure the transportation safety bolts have been removed. The laundry quantity might be too little, so add more laundry. Avoid overloading the machine; remove some items or redistribute the load evenly. Finally, confirm that the machine isn't leaning on any rigid item.
How to stop foam overflowing from the detergent drawer of my Beko Washer?
If foam is overflowing from the detergent drawer of your Beko Washer, it's likely due to using too much detergent. To resolve this, mix 1 tablespoon of softener with ½ liter of water and pour it into the main wash compartment of the detergent drawer. Also, ensure you are using detergent suitable for the programmes and maximum loads indicated in the 'Programme and consumption table'. Reduce the amount of detergent when using additional chemicals like stain removers or bleaches.
Why does the programme time not countdown on my Beko WRE6511WBD?
If the programme time on your Beko Washer (on models with a display) is not counting down, the timer may pause during water intake until the machine takes in an adequate amount of water. The timer may also stop during the heating step until the machine reaches the selected temperature. Additionally, the timer can stop during the spinning step if the automatic unbalanced load detection system is activated due to uneven laundry distribution. If the laundry is not evenly distributed, rearrange it and re-spin.
To Next Page
General