What to do if my Beko WTE 5411 B0 does not drain water?
If your Beko washer isn't draining water, the drain hose might be clogged or twisted, so clean or flatten the hose. Alternatively, the pump filter could be clogged, so clean the pump filter.
How to open a stuck door on my Beko Washer?
If the loading door of your Beko washer won't open, it could be due to several reasons. The door lock might be activated because of the water level, so drain the water by running the Pump or Spin programme. The machine might be heating or spinning, so wait until the programme completes. The child lock might be engaged, so wait a couple of minutes after the programme ends. The door may be stuck due to pressure, so grab the handle and push and pull the door to release it.
Why is my Beko Washer leaking water from the bottom?
If your Beko washing machine is leaking water from the bottom, it could be due to a clogged or twisted water drain hose, so clean or flatten the hose. Alternatively, the pump filter might be clogged, so clean the pump filter.
What to do if Beko Washer program does not start?
If the program on your Beko washer doesn't start after closing the door, ensure that you press the Start / Pause / Cancel button. Also, if the loading door is difficult to close due to excessive loading, reduce the amount of laundry and make sure the door is closed properly.
Why does my Beko WTE 5411 B0 Washer enter standby mode or not take in water?
Your Beko washer might enter standby mode or fail to take in water for a few reasons. Check if the tap is turned off and turn it on. See if the water inlet hose is bent and flatten it. The water inlet filter may be clogged, so clean it. Ensure the loading door is closed properly. Also, the water connection may be wrong or water may be cut off. If the water is cut off, press the Start/Pause key after the water has been supplied again to resume the operation from standby mode.
Why can't I start or select a programme on my Beko Washer?
If you cannot start or select a programme on your Beko washer, it may have switched to self-protection mode due to a supply problem (line voltage, water pressure, etc.). To cancel the programme, turn the Programme Selection knob to select another programme. The previous programme will be canceled.
Why did my Beko WTE 5411 B0 stop soon after starting?
Your Beko washer might have stopped temporarily due to low voltage. It will resume running when the voltage restores to the normal level.
Why does my Beko WTE 5411 B0 Washer immediately discharge the water?
If your Beko washer immediately discharges the water it takes in, the draining hose might not be at an adequate height. Connect the water draining hose as described in the operation manual.
Why can't I see water in my Beko WTE 5411 B0 during washing?
The water level is not visible from outside of the Beko washing machine. This is not a failure.
Why is my Beko WTE 5411 B0 Washer vibrating and making noise?
Your Beko washer may be vibrating or making noise due to several reasons. The machine might be standing unbalanced, so adjust the feet to level it. A hard substance might have entered the pump filter, so clean the pump filter. Ensure that the transportation safety bolts are removed. The laundry quantity might be too little, so add more laundry. The machine might be overloaded, so take some laundry out or distribute it evenly. Finally, ensure the machine isn't leaning on anything.
Safety instructions to prevent injuries and material damage.
Safety guidelines for children using the appliance.
Safety measures related to electrical connections and usage.
Precautions regarding hot surfaces during operation.
Information on product disposal and recycling.
Details about recyclable packaging materials.
Guidance on choosing the correct location for installation.
Steps to remove packaging reinforcement before installation.
Procedure for removing transportation safety bolts.
Instructions for connecting the water supply hose.
Guidelines for connecting the drain hose.
How to level and balance the machine using adjustable feet.
Proper electrical connection requirements and safety.
Preparations and initial steps before the first wash.
Guidance on sorting laundry by fabric, color, and soiling.
Tips for preparing clothes, like removing metal parts.
Advice on using the machine efficiently and saving energy.
Instructions on how to load laundry into the machine correctly.
Information on maximum load capacity and its impact.
Guidance on selecting and using detergents and softeners.
Table providing washing tips based on soiling level and garment type.
Explanation of the control panel buttons, knobs, and indicators.
Steps to prepare the machine before starting a wash cycle.
Guidance on selecting programmes and efficient washing tips.
Table detailing wash programmes, load capacity, duration, and consumption.
Descriptions of the primary washing programmes available.
Information on special or additional washing programmes.
Details on specific programmes like Rinse and Spin+Drain.
How to adjust and select spin speeds for programmes.
How to use the delayed start function for scheduling washes.
Steps to start a selected washing programme.
How to activate and use the child lock feature.
How to monitor the progress of a running wash programme.
Explanation of the loading door locking mechanism.
How to change settings during a programme.
Procedure for cancelling an ongoing wash programme.
Steps to follow when the washing programme has finished.
Explanation of the machine's automatic energy-saving pause mode.
Instructions for cleaning the detergent dispenser drawer.
How to clean the loading door seal and the drum.
Method for cleaning the exterior of the machine.
Procedure for cleaning the filters at the water inlet.
Steps for draining water and cleaning the pump filter.
Solutions for problems related to starting the program.
Solutions for water intake, drainage, and leakage issues.
Troubleshooting for operational errors and noise.
Solutions for water leaks and door locking problems.
Reasons and solutions for washing times exceeding the manual.
Troubleshooting for the program timer not counting down.
Solutions for the machine not switching to the spinning step.
Causes and solutions for laundry turning gray.
Solutions for persistent stains or lack of whitening.
Solutions for oily stains appearing on laundry.
Causes and solutions for unpleasant smells on clothes.
Reasons and solutions for clothes fading.
Troubleshooting for inadequate rinsing performance.
Solutions for laundry becoming stiff after washing.
Causes and solutions for laundry not smelling of softener.
Troubleshooting for detergent residue in the dispenser.
Solutions for excessive foam formation in the machine.
Solutions for laundry remaining wet after the program.
General| Type | Freestanding |
|---|---|
| Load Capacity | 5 kg |
| Energy Efficiency Class | A+++ |
| Spin Speed | 1000 RPM |
| Height | 84 cm |
| Width | 60 cm |
| Spin Drying Efficiency Class | B |
| Noise Level Spinning | 76 dB |
| Colour | White |
| Number of Programs | 15 |
To Next Page
