How to fix a Beko WTE 6511 BW that won't drain?
If your Beko Washer isn't draining water, the issue might be: * A clogged or twisted drain hose; clean or flatten the hose. * A clogged pump filter; clean the pump filter.
Why is my Beko WTE 6511 BW leaking water from the bottom?
If your Beko Washer is leaking water from the bottom, it might be due to: * A clogged or twisted water drain hose; clean or flatten the hose. * A clogged pump filter; clean the pump filter.
Why won't my Beko WTE 6511 BW program start after closing the door?
If your Beko Washer program doesn't start after closing the door: * Ensure you've pressed the Start / Pause / Cancel button. * If the loading door is difficult to close, you may have overloaded the machine; reduce the laundry amount and ensure the door is properly closed.
What to do if the loading door of my Beko WTE 6511 BW won't open?
If the loading door of your Beko Washer won't open, here are a few possible reasons and solutions: * The door lock may be activated due to the water level; drain the water by running the Pump or Spin programme. * The machine may be heating water or spinning; wait until the programme completes. * The child lock may be engaged; wait a couple of minutes after the programme ends for deactivation. * The door may be stuck due to pressure; try pushing and pulling the door to release it.
Why doesn't my Beko WTE 6511 BW Washer rinse well?
Poor rinsing in your Beko Washer can occur due to: * Inappropriate detergent (amount, brand, storage); use a suitable detergent, stored properly. * Detergent in the wrong compartment; put detergent in the correct compartment. * A clogged pump filter; check the filter. * A folded drain hose; check the drain hose.
What to do if my Beko WTE 6511 BW Washer enters standby mode or doesn't take in water?
If your Beko Washer enters standby mode or doesn't take in water, check the following: * Ensure the tap is turned on. * Check if the water inlet hose is bent and flatten it. * Clean the water inlet filter if it's clogged. * Make sure the loading door is closed properly. * Verify the water connection and ensure water is supplied; press the Start/Pause key to resume operation.
Why is my Beko Washer vibrating so much?
If your Beko Washer is vibrating or making excessive noise, several factors could be the cause: * The machine might be unbalanced; adjust the feet to level it. * A hard substance may be in the pump filter; clean the filter. * Transportation safety bolts might not be removed; remove them. * The laundry quantity might be too little; add more laundry. * The machine might be overloaded; remove some laundry or distribute the load evenly. * The machine might be leaning on something; ensure it's not touching anything.
Why does my Beko WTE 6511 BW Washer take longer than expected?
Several factors can cause your Beko Washer to take longer than the time specified in the manual: * Low water pressure: The machine waits for an adequate amount of water, extending the wash time. * Low voltage: Washing time is prolonged to avoid poor results. * Low input water temperature: Heating the water takes longer, especially in cold seasons. * Increased rinsing: The machine may increase rinse water or add an extra rinse if needed. * Excessive foam: The automatic foam absorption system may activate due to too much detergent.
Why is there too much foam in my Beko WTE 6511 BW?
Excessive foam in your Beko Washer can be due to: * Using improper detergents; use detergents specifically for washing machines. * Using too much detergent; use only a sufficient amount. * Improper detergent storage; store detergent in a closed, dry, and not excessively hot location. * Foaming fabrics: Some meshed laundry items may create excessive foam; use less detergent for these. * Detergent in the wrong compartment; put the detergent in the correct compartment. * Softener being taken early.
Why is there detergent residue in the detergent drawer of my Beko Washer?
Detergent residue in the drawer of your Beko Washer could be due to several reasons: * Putting detergent in a wet drawer; dry the drawer before adding detergent. * Damp detergent; keep detergents closed in a humidity-free environment, away from high temperatures. * Low water pressure; check the water pressure. * Blocked detergent compartment holes; check and clean if clogged. * Detergent mixed with softener; do not mix, and clean the dispenser with hot water.
General| Door hinge | Left |
|---|---|
| Cord length | 1.4 m |
| Drum volume | 39 L |
| Control type | Buttons, Rotary |
| Display type | LCD |
| Loading type | Front-load |
| Certification | CE, VDE |
| Drum material | Stainless steel |
| Product color | White |
| Built-in display | Yes |
| Door opening angle | 170 ° |
| Appliance placement | Freestanding |
| Drum capacity | 6 kg |
| Cycle time (max) | 195 min |
| Delay start (max) | 9 h |
| Residual moisture | 62 % |
| Spin-drying class | C |
| Maximum spin speed | 1000 RPM |
| Noise level (spin) | 77 dB |
| Noise level (wash) | 61 dB |
| Number of washing programs | 9 |
| Current | 10 A |
| Connected load | 1550 W |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Power consumption (off) | 0.25 W |
| Power consumption (standby) | 0.75 W |
| Energy consumption washing per cycle | 0.59 kWh |
| Annual water consumption washing | 8799 L |
| Annual energy consumption washing | 152 kWh |
Weight and Dimensions| Depth | 440 mm |
|---|---|
| Width | 600 mm |
| Height | 840 mm |
| Weight | 55000 g |
Safety instructions to prevent injuries and material damage risks.
Guidelines for safe usage by children and supervision requirements.
Precautions for safe electrical connections and usage to avoid shock.
Comprehensive list of product's technical data and performance metrics.
Guidelines for connecting the water inlet hose and required water pressure.
Instructions for properly attaching the drain hose for water discharge.
Safe connection of the product to the grounded electrical outlet.
Guide on how to use detergents, softeners, and their correct compartments.
Explanation of the control panel buttons, LEDs, and display elements.
Instructions for cleaning detergent drawer, drum, body, and control panel.
Steps to drain residual water and clean the pump filter for maintenance.
Solutions for common issues like program start failure, water intake, and drainage.
To Next Page
