What to do if my Beko WTE 7511 BW does not drain water?
If your Beko Washer isn't draining water, the drain hose might be clogged or twisted; try cleaning or flattening the hose. Additionally, the pump filter could be clogged, so cleaning the pump filter may solve the problem.
What to do if my Beko WTE 7511 BW won't switch to the spinning step?
If your Beko Washer isn't switching to the spinning step, there might be an unbalanced load inside the machine. The automatic unbalanced load detection system could be activated. Also, if the water hasn't drained completely, the machine won't spin, so check the filter and the draining hose. Excessive foam from using too much detergent can also prevent spinning; use the recommended amount of detergent.
Why is there water leaking from the bottom of my Beko WTE 7511 BW Washer?
If you notice water leaking from the bottom of your Beko washing machine, the water drain hose might be clogged or twisted, so you should clean or flatten the hose. Another possible cause is a clogged pump filter, which also needs cleaning.
What to do if my Beko Washer programme does not start after closing the door?
If your Beko Washer program doesn't start after closing the door, make sure you have pressed the Start / Pause / Cancel button. Also, if you have loaded too much laundry, it may be difficult to close the loading door, so reduce the amount of laundry and ensure the door is properly closed.
Why does my Beko Washer not rinse well?
If your Beko Washer isn't rinsing well, the amount, brand, and storage conditions of the detergent might be inappropriate. Use a detergent suitable for washing machines and your laundry, and store detergents properly in a humidity-free environment. Ensure detergent is put in the correct compartment. Also, check if the pump filter or drain hose is clogged or folded.
Why does my Beko WTE 7511 BW enter standby mode or not take in water?
Your Beko Washer might enter standby mode or fail to take in water for several reasons. Check if the tap is turned off and turn it on. Ensure the water inlet hose isn't bent; if it is, flatten it. A clogged water inlet filter can also cause this, so clean the filter. Make sure the loading door is completely closed. Also, verify the water connection and ensure that the water supply isn't cut off. If it was cut off, press the Start/Pause button to resume operation once the water supply is restored.
Why does my Beko Washer take longer than the manual says?
The washing cycle may take longer than usual for several reasons. The water pressure might be low, causing the machine to wait until it has enough water. Low voltage can also extend the washing time to ensure good results. If the water entering the machine is cold, especially in colder seasons, the heating process will take longer. Additionally, the machine may increase the amount of rinse water or add an extra rinse if it's needed. Excessive foam from too much detergent can also activate the automatic foam absorption system, prolonging the wash time.
What to do if my Beko Washer vibrates or makes noise?
If your Beko Washer is vibrating or making excessive noise, several factors could be the cause. First, make sure the machine is standing level by adjusting the feet. A hard object may have entered the pump filter, so clean the pump filter. Ensure that the transportation safety bolts have been removed. The laundry quantity might be too little or too much; adjust the load accordingly. Also, check that the machine isn't leaning against anything.
How to fix detergent residue in the drawer of my Beko WTE 7511 BW Washer?
Detergent residue in the drawer of your Beko Washer can occur for several reasons. Ensure you dry the detergent drawer before adding detergent. The detergent itself may have become damp, so store detergents properly in a dry, closed environment. Low water pressure can also cause this issue, so check the water pressure. Also, inspect the holes of the detergent compartment and clean them if they are blocked. Avoid mixing softeners with detergent and clean the dispenser with hot water. In some cases, the detergent drawer valves may have a problem, requiring a call to an authorized service agent.
Why is my Beko Washer washing performance poor and laundry turns gray?
Poor washing performance resulting in gray laundry can stem from several issues. You might not be using enough detergent over time, so ensure you use the recommended amount appropriate for the water hardness and the laundry load. Washing at low temperatures for extended periods can also cause this, so select the proper temperature. Using too little detergent with hard water can also cause graying. Avoid overloading the machine and select the correct program. Also, ensure you're using the right type of detergent.
General| Capacity | 7 kg |
|---|---|
| Energy Efficiency Class | A+++ |
| Dimensions (H x W x D) | 84 cm x 60 cm x 49 cm |
| Weight | 55 kg |
| Water consumption per cycle | 45 L |
| Water Consumption | 45 L |
| Number of Programs | 15 |
To Next Page
