Why did my Beko WTE 9744 N Washer stop soon after starting?
If your Beko Washer stopped shortly after the programme started, the machine has stopped temporarily due to low voltage. The product will resume running when the voltage restores to the normal level.
How to open a Beko Washer door that is stuck?
If the loading door of your Beko Washer won't open, it could be due to several reasons. The loading door lock might be activated because of the water level, so drain the water by running the Pump or Spin programme. The product might be heating up the water or at the spinning cycle, so wait until the programme completes. The loading door may be stuck because of pressure, so grab the handle and push and pull the loading door to release it. If there is no power, the loading door will not open, so open the pump filter cap and pull down the emergency handle positioned at the rear side of the cap. See "Opening the loading door in case of power failure".
Why is my Beko Washer leaking water from the bottom?
If you notice water leaking from the bottom of your Beko Washer, it could be due to a clogged or twisted water drain hose, so clean or flatten the hose. Alternatively, the pump filter might be clogged, so clean the pump filter.
Why is my Beko Washer not rinsing well?
If your Beko Washer isn't rinsing well, the amount, brand, and storage conditions of the detergent might be inappropriate, so use a detergent suitable for washing machines and laundry, and store it properly. Ensure detergent is put in the correct compartment; if it's in the prewash compartment without prewash being selected, it can interfere with rinsing. A clogged pump filter or a folded drain hose can also cause poor rinsing, so check the filter and the drain hose.
Why won't programs start on my Beko WTE 9744 N Washer?
If programs on your Beko Washer aren't starting after closing the loading door, make sure you press the Start / Pause / Cancel button. Also, excessive loading can make it difficult to close the door properly, so reduce the amount of laundry and ensure the door is closed correctly.
Why is foam overflowing from the detergent drawer of my Beko Washer?
If foam is overflowing from the detergent drawer of your Beko Washer, it could be because too much detergent is used, so mix 1 tablespoonful of softener with ½ l of water and pour it into the main wash compartment. Also, put detergent into the product suitable for the programmes and maximum loads indicated in the “Programme table”. When you use additional chemicals (stain removers, bleaches, etc), reduce the amount of detergent.
Why did the color of my clothes fade after washing in the Beko Washer?
If the color of clothes faded after washing in your Beko Washer, it might be because excessive laundry was loaded, so avoid overloading. The detergent in use may be damp, so keep detergents properly stored. A higher temperature might have been selected, so select the proper programme and temperature according to the laundry's type and soiling degree.
Why doesn't my laundry smell like softener after using my Beko WTE 9744 N Washer?
If your laundry doesn't smell like the softener after washing in your Beko Washer, it could be because detergent was put in the wrong compartment, so put the detergent in the correct compartment and wash and clean the drawer with hot water. Also, avoid mixing the softener with detergent and clean the drawer with hot water.
Why is my Beko WTE 9744 N not cleaning well?
If your Beko Washer isn't cleaning well, and stains persist or laundry isn't whitened, it could be due to several reasons. You might be using an insufficient amount of detergent, so use the recommended amount appropriate for water hardness and the laundry. Avoid loading excessive laundry. Ensure you've selected the proper programme and temperature for the laundry. Using the wrong type of detergent can also cause this, so use original detergent appropriate for the product. Finally, avoid using an excessive amount of detergent and put the detergent in the correct compartment, without mixing bleaching agent and the detergent.
Why is my Beko Washer vibrating or making noise?
If your Beko Washer is vibrating or making noise, several factors could be the cause. Ensure the washer is standing balanced by adjusting the feet. A hard substance might have entered the pump filter, so clean the pump filter. Check that the transportation safety bolts have been removed. The laundry quantity could be too little, so add more laundry. If excessive laundry is loaded, take some out or distribute the load evenly. Finally, make sure the product isn't leaning on anything.
General| Type | Front Load |
|---|---|
| Load Capacity | 9 kg |
| Energy Efficiency Class | A+++ |
| Spin Speed | 1400 rpm |
| Noise Level (Washing) | 54 dB |
| Noise Level (Spinning) | 74 dB |
| Number of Programs | 15 |
| Delay Start | Yes |
| Child Lock | Yes |
| Water Consumption | 50 L |
To Next Page
